SiS APIC, hacker looking for docs/help, was : Re: 2.6.4 under heavy ioload disables sis5513 DMA
<snip>
Quoted 14 lines
Quoted 14 lines
Dunno how DMA timeout is related to interrupts or are you suggesting it is loosing dma-complete interrupts?
I don't know the details (yet I hope), but I'm quite sure that interrupt handling in XT-PIC mode leads to problems on several SiS configurations (when you reorganize PCI cards in a system and the behaviour changes or when you disable the VGA IRQ and some things start to work, the suspect becomes obvious). One user reported that putting 2 disks on one channel instead of one on each (so 1 IRQ used instead of 2) solve instability issues too... I ruled out IDE driver problems several times by repeatedly checking the code and the run-time register values against known-good values. My lack of knowledge on the interrupt handling details is what prevents me from being 100% sure that the problem lies here. This is why I'm willing to work on this subject.
I had a report that my patch helped an sis740 board run in apic ioapic mode. Don't know if it would help your situation. Here is relevant link.
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-03/4278.html
There is a problem with apm mode with my patch - small fix here if reqd.
http://linux.derkeiler.com/Mailing-Lists/Kernel/2004-03/4410.html
Hope it helps.
Ross.
Quoted 3 lines
Quoted 3 lines
Same board runs same and higher loads with 2.4.2[345] flawlessly. Also 8 hours OK with 2.4.26-pre4 last night + 430 cycles of swsusp2.