Skip to contentSkip to conversation

Major problem with RME HDSP/Multiface and a 64-bit AMD laptop -- SOLVED!!! (partially)

DISCUSSION Ivica Ico Bukvic 2 participants 3 messages Mar 21, 2004

lore
Share & tools
lore
#0 lore raw

Hi all!

After some tinkering with the drivers, I've done unthinkable :-) -- the cardbus now works flawlessly in Windoze (for Linux read below).

What I basically did is investigated the current driver in Windoze for the carbus and it came up as a "generic cardbus interface." I was by now aware that the exact cardbus chipset is/was ENE C1410. So I did some searching on the Google for the driver and came up with HP's driver download page for one of their laptops (mine is eMachines m6807). So, I said what the heck, at this point I just might as well go ahead and try it. So I downloaded the driver (link:
http://h18007.www1.hp.com/support/files/hpcpqnk/us/download/18388.html)
installed it, it went without a hitch and asked me to reboot. Upon rebooting the device manager listed the pcmcia interface as the "ENE C1410 Cardbus Interface." So far, so good! Upon reconnecting the RME HDSP and playing the sound, the sound was absolutely flawless at 3ms latency!!! Yay!

Now, I need to do more testing to see exactly what are the real limits of the cardbus, but as of right now, everything seems to be working fine. This laptop is a real gem after all (for $1400 is simply unbeatable, especially considering that the voodoopc sells the exact same chasis with a bit faster processor for $3200!).

However, there is one aspect that is yet to be resolved, and that is Linux + cardbus issue. With the hardware concerns now being out of the way (obviously driver upgrade in Windoze has proven that it was software-based), this leads me to believe that the Linux kernel's yenta_socket module that is currently being used for this particular ENE C1410 cardbus is apparently not quite compatible with it. Hence, whoever has any access to the kernel/pcmcia module developers/maintainers, I would greatly appreciate it if you could please forward this info to them, as it may prove to be valuable.

Anyhow, I guess this time around the story has a happy ending after all. Many thanks to everyone for your assistance in this matter! At least in Linux it is simply a matter of time until the drivers are properly tweaked (unless ACPI/APIC has also something to do with it).

Best wishes,

Ivica Ico Bukvic, composer & multimedia sculptor
http://meowing.ccm.uc.edu/~ico/

-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials Free Linux tutorial presented by Daniel Robbins, President and CEO of GenToo technologies. Learn everything from fundamentals to system administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click

#1 lore raw
Quoted 4 lines

What I basically did is investigated the current driver in Windoze for the carbus and it came up as a "generic cardbus interface." I was by now aware that the exact cardbus chipset is/was ENE C1410. So I did some searching on the Google for the driver and came up with HP's driver download page for one

Quoted 8 lines

of their laptops (mine is eMachines m6807). So, I said what the heck, at this point I just might as well go ahead and try it. So I downloaded the driver (link:
http://h18007.www1.hp.com/support/files/hpcpqnk/us/download/18388.html)
installed it, it went without a hitch and asked me to reboot. Upon rebooting the device manager listed the pcmcia interface as the "ENE C1410 Cardbus Interface." So far, so good! Upon reconnecting the RME HDSP and playing the sound, the sound was absolutely flawless at 3ms latency!!! Yay!

If I may say so, that is just bloody amazing. Congratulations on this bit of sleuthing.

Its too bad that getting this to work under Linux will likely require a lot more effort on the part of many more people.

--p

-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials Free Linux tutorial presented by Daniel Robbins, President and CEO of GenToo technologies. Learn everything from fundamentals to system administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click

#2 lore raw

Thanks! :-)

I did however realize one more thing and that is if I put my laptop to either standby or hibernate mode in Windoze, the dreaded distortion returns back to haunt me. :-( OTOH, a simple reboot does fix it. So, I guess it's not the best possible solution but at least it works. My guess is that this is a direct result of a crappy BIOS and/or APCI implementation.

So far I've tested it only with 4 outputs at 44.1KHz and it ran fine at 3ms. 1.5ms does introduce artifacts, but that really does not bother me.

Unfortunately in Linux I am yet to figure out how to fix the distortion. It is conceivable that the fix could be achieved by simply passing some flags in the pcmcia config (/etc/sysconfig/pcmcia), but as to which, I don't have the faintest clue :-(.

Best wishes,

Ivica Ico Bukvic, composer & multimedia sculptor
http://meowing.ccm.uc.edu/~ico/

Quoted 29 lines

-----Original Message-----
From: Paul Davis [mailto:[email protected]]
Sent: Sunday, March 21, 2004 12:08 AM
To: Ivica Ico Bukvic
Cc: [email protected]; [email protected]; linux-audio- [email protected]; [email protected]; alsa- [email protected]; [email protected]
Subject: Re: [Alsa-devel] RE: Major problem with RME HDSP/Multiface and a 64-bit AMD laptop -- SOLVED!!! (partially)

Quoted 1 line

What I basically did is investigated the current driver in Windoze for

the

Quoted 1 line

carbus and it came up as a "generic cardbus interface." I was by now

aware

Quoted 1 line

that the exact cardbus chipset is/was ENE C1410. So I did some searching

on

Quoted 1 line

the Google for the driver and came up with HP's driver download page for

one

Quoted 5 lines

of their laptops (mine is eMachines m6807). So, I said what the heck, at this point I just might as well go ahead and try it. So I downloaded the driver (link:
http://h18007.www1.hp.com/support/files/hpcpqnk/us/download/18388.html)
installed it, it went without a hitch and asked me to reboot. Upon

rebooting

Quoted 2 lines

the device manager listed the pcmcia interface as the "ENE C1410 Cardbus Interface." So far, so good! Upon reconnecting the RME HDSP and playing

the

Quoted 1 line

sound, the sound was absolutely flawless at 3ms latency!!! Yay!

Quoted 7 lines

If I may say so, that is just bloody amazing. Congratulations on this bit of sleuthing.

Its too bad that getting this to work under Linux will likely require a lot more effort on the part of many more people.

--p

-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials Free Linux tutorial presented by Daniel Robbins, President and CEO of GenToo technologies. Learn everything from fundamentals to system administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click