Skip to contentSkip to conversation

cciss update to replace 1 of 2 earlier patches

PATCH [email protected] 1 participant 1 message Mar 25, 2004 Block layer

lore
Share & tools
lore
#0 lore raw

This patch is meant to replace the patch from earlier that mask off SATA drives. After Arjan's question about one for 2.6 I got back in the code and realized this has to be done in 2 places for the 2.4.x driver, but only in one place for 2.6. Also, to answer Jeff's question: if it's not a SCSI tape we don't care.

This change is required to support the new MSA30 storage enclosure.
If you do a SCSI inquiry to a SATA disk bad things happen. This patch prevents the inquiry from going to SATA disks.

 cciss_scsi.c |    3 +++
 1 files changed, 3 insertions(+)

------------------------------------------------------------------------------

drivers/block/cciss_scsi.c +3 -0
diff -burpN lx2425.orig/drivers/block/cciss_scsi.c lx2425/drivers/block/cciss_scsi.c
@@ -589,6 +589,8 @@ cciss_find_non_disk_devices(int cntl_num
 
 	for(i=0; i<num_luns; i++) {
 		/* Execute an inquiry to figure the device type */
+		/* Skip over masked devices */
+		if (ld_buff->LUN[i][3] & 0xC0) continue;
 		memset(inq_buff, 0, sizeof(InquiryData_struct));
 		memcpy(scsi3addr, ld_buff->LUN[i], 8); /* ugly... */
 		return_code = sendcmd(CISS_INQUIRY, cntl_num, inq_buff,
@@ -1148,6 +1150,7 @@ cciss_update_non_disk_devices(int cntl_n
 		int devtype;
 
 		/* for each physical lun, do an inquiry */
+		if (ld_buff->LUN[i][3] & 0xC0) continue;
 		memset(inq_buff, 0, sizeof(InquiryData_struct));
 		memcpy(&scsi3addr[0], &ld_buff->LUN[i][0], 8);