Skip to contentSkip to conversation

Boot problems on MPC8250!!!

DISCUSSION jeffy 1 participant 1 message Mar 31, 2004

lore
Share & tools
lore

jeffy

author
#0 lore raw

Hi all:
I am porting U-BOOT and PPCLinux to my MPC8250 board, now when UBOOT
boots up and it can runs serveral steps, after the entry "serial_init()" in board_init_f(), it hangs! I add a "serial_puts("***")" at the end serial_init(), it can print out, and in UBOOT, the next entry after "serial_init" should be "console_init_f", so I and a "serial_puts("aaaa")" at the begin of "console_init_f", it don't print out! (the soft watch dog is disabled), why about this?

Thanks a lot!
Best Regards!

jeffy
[email protected]

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/