Skip to contentSkip to conversation

powernow-k8: broken PSB

DISCUSSION Christoph Terhechte 2 participants 2 messages Apr 2, 2004 – Apr 9, 2004

lore
Share & tools
lore
#0 lore raw

Hi,

I'm running Gentoo Linux on an Athlon 64 system (board is Asus 8KV SE Deluxe). I was getting the "BIOS error - no PSB" message when trying to "modprobe powernow-k8", so I upgraded to 2.6.5-rc3-mm4 which includes Pavel Machek's new powernow-k8 driver. Theoretically, it should be getting tables through ACPI and ignore the legacy PST/PSB tables, but I'm still getting the same error as before and inserting powernow-k8 fails with this message:

FATAL: Error inserting powernow_k8 (/lib/modules/2.6.5-rc3-mm4/kernel/arch/x86_64/cpufreq/powernow-k8.ko):
No such device

Is there anything I need to tell the kernel explicitly to inform it not to use the legacy method? Any kernel options I might have overlooked?

BIOS support for ACPI 2.0 is activated and APIC APIC Supprt enabled. I'm confused about this boot message, though:

PCI bridge 00:01 from 1106 found. Setting "noapic". Overwrite with "apic"

Signature · 6 lines
Christoph Terhechte <[email protected]>
International Forum of New Cinema
Potsdamer Strasse 2
D-10785 Berlin
Tel: +49-30-269.55.200
Fax: +49-30-269.55.222
#1 lore raw

Hi!

Quoted 11 lines

I'm running Gentoo Linux on an Athlon 64 system (board is Asus 8KV SE Deluxe). I was getting the "BIOS error - no PSB" message when trying to "modprobe powernow-k8", so I upgraded to 2.6.5-rc3-mm4 which includes Pavel Machek's new powernow-k8 driver. Theoretically, it should be getting tables through ACPI and ignore the legacy PST/PSB tables, but I'm still getting the same error as before and inserting powernow-k8 fails with this message:

FATAL: Error inserting powernow_k8 (/lib/modules/2.6.5-rc3-mm4/kernel/arch/x86_64/cpufreq/powernow-k8.ko):
No such device

Try putting it directly into kernel.
Pavel

Signature · 2 lines
When do you have a heart between your knees?
[Johanka's followup: and *two* hearts?]