help setting up router
Hi, my name is Calin and I'm new to linux, but I guess its the right place to ask this:
what do I set on a linux RH9 box with 2.4.24 kernel to route a 10 machine private network (192.168.x.x) by 3 limited bandwidth, public IPs (193.231.x.x). The network uses a switch, the linux box has 1 ethernet card, the link is available trough a wireles ethernet bridge from my ISP.
I begun to read routing and IP howtos. I thing that I need some virtual ethernet adapters and SNAT routing.
tia
----
Home, no matter how far...
http://www.home.ro
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 10 lines · calin popa
Hi, my name is Calin and I'm new to linux, but I guess its the right place to ask this:
what do I set on a linux RH9 box with 2.4.24 kernel to route a 10 machine private network (192.168.x.x) by 3 limited bandwidth, public IPs (193.231.x.x). The network uses a switch, the linux box has 1 ethernet card, the link is available trough a wireles ethernet bridge from my ISP.
I begun to read routing and IP howtos. I thing that I need some virtual ethernet adapters and SNAT routing.
It sounds like you want to use NAT. Stick another NIC in your Linux box and configure it as your gateway. All of that is rather simple. I'd suggest these documents:
http://iptables-tutorial.frozentux.net/iptables-tutorial.html
http://www.linux-ip.net/html/
If you want to load balance across your three public IPs or do traffic shaping across the wireless link, that's more ARTC.
Quoted 2 lines
tia
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/