Skip to contentSkip to conversation

atyfb: Blank LCD by turning off backlight voltage

PATCH New Ville Syrjälä 1 participant 1 message Jun 17, 2004 Framebuffer layer

lore
Share & tools
lore

Ville Syrjälä

author
#0 lore raw

PATCH 1/1 atyfb: Blank LCD by turning off backlight voltage

This patch makes the blanking code turn the backlight voltage on/off.

Signature · 3 lines
Ville Syrjälä
[email protected]
http://www.sci.fi/~syrjala/
drivers/video/aty/atyfb_base.c +17 -2
diff -urN linux-orig/drivers/video/aty/atyfb_base.c linux/drivers/video/aty/atyfb_base.c
@@ -2464,7 +2464,14 @@
 #ifdef CONFIG_PMAC_BACKLIGHT
 	if ((_machine == _MACH_Pmac) && blank)
 		set_backlight_enable(0);
-#endif /* CONFIG_PMAC_BACKLIGHT */
+#elif defined(CONFIG_FB_ATY_GENERIC_LCD)
+	if (par->lcd_table && blank &&
+	    (aty_ld_lcd(LCD_GEN_CNTL, par) & LCD_ON)) {
+		u32 pm = aty_ld_lcd(POWER_MANAGEMENT, par);
+		pm &= ~PWR_BLON;
+		aty_st_lcd(POWER_MANAGEMENT, pm, par);
+	}
+#endif
 
 	gen_cntl = aty_ld_8(CRTC_GEN_CNTL, par);
 	if (blank > 0)

@@ -2488,7 +2495,15 @@
 #ifdef CONFIG_PMAC_BACKLIGHT
 	if ((_machine == _MACH_Pmac) && !blank)
 		set_backlight_enable(1);
-#endif /* CONFIG_PMAC_BACKLIGHT */
+#elif defined(CONFIG_FB_ATY_GENERIC_LCD)
+	if (par->lcd_table && !blank &&
+	    (aty_ld_lcd(LCD_GEN_CNTL, par) & LCD_ON)) {
+		u32 pm = aty_ld_lcd(POWER_MANAGEMENT, par);
+		pm |= PWR_BLON;
+		aty_st_lcd(POWER_MANAGEMENT, pm, par);
+	}
+#endif
+
 	return 0;
 }