CS4232 powerdown behavior
Hi,
I'm curious about a behavior of the CS4232. It is possible to software powerdown the chip. However, I can't get the chip to power back up. reading p62 of the databook, it mentions RESDRV external pin. Is this pin the only way to bring the CS4232 back up, or is there a way to do it
through software? It is mentioned on p.46 that the SB/PNP/MPU401
automatically resume if they are accessed, but this seems to be not so for the WSS component. (It reads as 0x80 forever.) Additionally, if I load snd-sb8 driver to use the SB component after it has been powered down, the system is hung when a play is attempted. (Usually snd-sb8 works fine when snd-cs4232 is not loaded, and vice versa)
I power down by setting |= 0xc0 to CTRLbase. I have also tried setting PDP. Does anyone know what the difference between the registers is? The functionality seems similar, as described by the databook.
anyone who knows something about CS4231(a)/CS4232 could help me. this is on a toshiba 500cdt laptop btw. I have a feeling that some special register is used to drive RESDRV (similar to how my thinkpad 755c's cs4248 was enabled). The reason why I have this feeling is that a ctrl-alt-del reboot enables the sound chip again. This makes me think the BIOS is doing something to enable it. If I can hack the BIOS to find that register then we will be able to have power management for sound on this laptop. I am guessing the reason there is no real PM for this chip otherwise, is because there is no general way to turn it back on in software once it has been turned off.
One other thing, does anyone know how CS4232's SBPro 2xOPL2 emulation is accomplished, when a OPL3 is the actual chip that is connected to the cs4232 synth port? This seems to be nonsense, but the databook does claim that 0x220 is left FM and 0x221 is right FM. I suppose I will have to test it. It might just behave like a SB16 with respect to the OPL3.
thanks!
Signature · 1 line
Ryan Underwood, <[email protected]>