Input patches

Vojtech,

Now that my driver core patches have been merged in Linus' tree I would like finish merging input patches. Please do:

bk pull bk//dtor.bkbits.net/input

You will pull the following patches (along with whatever was in Linus' tree as of last evening):

01-drivers-makefile.patch
- move input/serio closer to the top of drivers/Makefile so serio_bus structure initialized early and is ready by the time sunzilog and sunsu register their serio ports.

02-sunzilog-serio-register.patch
- Do not attempt to register serio ports while holding a spinlock and with interrupts off. Fully initialize hardware first and only then register. Cures lockup reported by WLI.

03-i8042-broken-mux-workaround.patch
- Some MUXes get confused what AUX port the byte came from. Assume that is came from the same port previous byte came from if it arrived within HZ/10

04-serio-pause-rx.patch
- Add serio_pause_rx and serio_continue_rx that take serio->lock and can be used by drivers to protect their critical sections from interrupt handler.

05-psmouse-set-state.patch
- Use serio_pause_rx/serio_continue_rx when changing psmosuee state (active, ignore)

06-psmouse-initializing.patch
- Add a new state PSMOUSE_INITIALIZING and do not try to call protocol handler for mice in this state. Shoudl help with OOPS caused by USB Legacy emulation generating wierd data stream when probing for mouse

07-synaptics-passthrough-handling.patch
- If data looks like a pass-through packet and tuchpad has pass- through capability do not pass it to the main handler if child port is disconnected. Let serio core sort it out and bind a proper driver to the port

08-psmouse-reconnect.patch
- Instead of wierd rule that connect should not activate mouse if there is a pass-through port and have child do activation do the following:
1. Connect/reconnect always activate port in question
2. If port is a pass-through port connect/reconnect will deactivate parent at the beginning of the probe and will activate it after everything is done.
This allows reliably reconnect children ports in response to user request (echo -n "reconnect" > /sys/bus...)

Continuing as for some reason half of the letter went into limbo...

09-mousedev-drop-attribute.packed
- drop __attribute__ ((packed)) from mousedev as we ca spare couple of bytes to get better code readability

10-i8042-platform-device.patch
- make i8042 a platform device (instead of system) device so its ports have a proper parent

11-serio-platform-devices.patch
- integrate ct82c710, maceps2, q40kbd and rpckbd with sysfs as platform devices so their serio ports have proper parents

12-serio-bus-default-attr.patch
- qwitch to use bus' default device and driver attributes to manage serio sysfs attributes

13-serio-manual-bind.patch
- allow marking serio ports (in addition to serio drivers) as manual bind only, export the flag through sysfs:
echo -n "manual" > /sys/bus/serio/devices/serio0/bind_mode echo -n "auto" > /sys/bus/serio/drivers/serio_raw/bind_mode

14-serio-use-driiver-find:
- use driver_find when doing manual binding, adjust refcounting as driver_find takes a reference.

I will not be sending individual patches as they have been posted couple times already and I'd hate spamming LKML once again.

Dmitry