Skip to contentSkip to conversation

Little question about imq device

LARTC Marcin Sura 2 participants 2 messages Aug 15, 2004

lore
Share & tools
lore
#0 lore raw

Witam

I've found many examples where packets are redirected to IMQ device in PREROUTING chain for ingress traffic shaping purposes.

But is there any sense in redirecting packets to IMQ in FORWARD chain also for ingress traffic shaping purposes?

Signature · 6 lines
Pozdrawiam
 Marcin                         mailto:[email protected]

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw

On Sun, 15 Aug 2004 19:03:58 +0200, Marcin Sura wrote

Quoted 7 lines

Witam

I've found many examples where packets are redirected to IMQ device in PREROUTING chain for ingress traffic shaping purposes.

But is there any sense in redirecting packets to IMQ in FORWARD chain also for ingress traffic shaping purposes?

Yes, I think, imagine something like this. Imagine you are the gateway of a whole class C , with ip 192.168.0.1 then :

tc qdisc add dev imq0 handle 1: root htb default 1 tc class add dev imq0 parent 1: classid 1:1 htb rate 64kbit tc qdisc add dev imq0 parent 1:1 handle 2 sfq

iptables -t mangle -A FORWARD -i eth0 -d 192.168.0.X -j IMQ

would prevent traffic coming from an outside network attached to the gw going to the 192.168.0.x host.

Daniel . ------- daniel_at_seriousworks.net
/Cabezas SeriousWorks Solutions, SCP
______/ Barcelona, Spain
www: http://www.seriousworks.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/