Skip to contentSkip to conversation

input: Disable the AUX LoopBack command in i8042.c on Compaq ProLiant

DISCUSSION Arjan van de Ven 2 participants 2 messages Sep 16, 2004 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 9 lines · Linux Kernel Mailing List

ChangeSet 1.1722.87.1, 2004/06/02 13:44:20+02:00, [email protected]

input: Disable the AUX LoopBack command in i8042.c on Compaq ProLiant
8-way Xeon ProFusion systems, as it causes crashes and reboots on these machines. DMI data is used for determining if the workaround should be enabled.

is there any reason you do this in dmi_scan.c and not via the "new" since some time method where the user gives the dmi code a table with callbacks instead ????

#2 lore raw
Quoted 8 lines · Arjan van de Ven
Quoted 7 lines · Linux Kernel Mailing List

ChangeSet 1.1722.87.1, 2004/06/02 13:44:20+02:00, [email protected]

input: Disable the AUX LoopBack command in i8042.c on Compaq ProLiant
8-way Xeon ProFusion systems, as it causes crashes and reboots on these machines. DMI data is used for determining if the workaround should be enabled.

Quoted 6 lines
Quoted 2 lines

is there any reason you do this in dmi_scan.c and not via the "new" since some time method where the user gives the dmi code a table with callbacks instead ????

There is no such reason other than on 06/02 there wasn't the "new" method yet, as far as I know. In the same set of patches:

[email protected], 2004-06-29 11:59:04+02:00, [email protected]
input: Move Compaq ProLiant DMI handling (ServerWorks/OSB workaround)

         to i8042.c.
Signature · 2 lines
Vojtech Pavlik
SuSE Labs, SuSE CR