2.6.x-rc net driver updates
Subsystems (3)
PATCH 1/1 2.6.x-rc net driver updates
Please do a
bk pull bk://gkernel.bkbits.net/net-drivers-2.6
This will update the following files:
drivers/ieee1394/eth1394.c | 2 drivers/net/Kconfig | 4 - drivers/net/r8169.c | 16 ++++- drivers/net/wireless/airo.c | 139 +++++++++++++++++++++++++------------------- 4 files changed, 97 insertions(+), 64 deletions(-)
through these ChangeSets:
<[email protected]> (04/09/20 1.1928)
[PATCH] Compatibility fixes for different card versions
<[email protected]> (04/09/20 1.1927)
[PATCH] r8169: default on disabling PCIDAC
Default to disabling PCI DAC as this option appears unsafe on amd64 (original suggestion by Hans-Frieder Vogt <[email protected]>).
The driver will typically report PCI System error when something goes wrong. The relevant interrupt is not masked any more and the driver can thus be disabled.
<[email protected]> (04/09/17 1.1926)
[PATCH] fix driver name in eth1394 as returned by ETHTOOL_GDRVINFO
From: Thierry Vignaud <[email protected]>
The GDRVINFO command of the ETHTOOL ioctl returns a bogus driver name.
<[email protected]> (04/09/16 1.1925)
[PATCH] mark mace and bmac as ppc32 only
mace and bmac are only used in "oldworld" PowerMacs. Mark them as ppc32 only.
drivers/ieee1394/eth1394.c +1 -1
@@ -132,7 +132,7 @@ };/* Our ieee1394 highlevel driver */ -#define ETH1394_DRIVER_NAME "ip1394" +#define ETH1394_DRIVER_NAME "eth1394"static const char driver_name[] =ETH1394_DRIVER_NAME ;static kmem_cache_t *packet_task_cache;
drivers/net/Kconfig +2 -2
@@ -200,7 +200,7 @@ config MACE tristate "MACE (Power Mac ethernet) support" - depends on NET_ETHERNET && PPC_PMAC + depends on NET_ETHERNET && PPC_PMAC && PPC32 select CRC32 help Power Macintoshes and clones with Ethernet built-in on the
@@ -223,7 +223,7 @@ config BMAC tristate "BMAC (G3 ethernet) support" - depends on NET_ETHERNET && PPC_PMAC + depends on NET_ETHERNET && PPC_PMAC && PPC32 select CRC32 help Say Y for support of BMAC Ethernet interfaces. These are used on G3
drivers/net/r8169.c +14 -2
@@ -156,6 +156,7 @@MODULE_DEVICE_TABLE (pci, rtl8169_pci_tbl);static int rx_copybreak =200 ; +static int use_dac;enum RTL8169_registers {MAC0 =0 ,/* Ethernet hardware address. */
@@ -358,6 +359,8 @@MODULE_DESCRIPTION ("RealTek RTL-8169 Gigabit Ethernet driver" ); MODULE_PARM(media, "1-" __MODULE_STRING(MAX_UNITS) "i");MODULE_PARM (rx_copybreak,"i" ); +MODULE_PARM (use_dac,"i" ); +MODULE_PARM_DESC (use_dac,"Enable PCI DAC. Unsafe on 32 bit PCI slot." );MODULE_LICENSE ("GPL" );static int rtl8169_open (struct net_device *dev);
@@ -375,7 +378,7 @@#endif static const u16 rtl8169_intr_mask = - LinkChg | RxOverflow | RxFIFOOver | TxErr | TxOK | RxErr | RxOK; + SYSErr | LinkChg | RxOverflow | RxFIFOOver | TxErr | TxOK | RxErr | RxOK;static const u16 rtl8169_napi_event = RxOK | RxOverflow | RxFIFOOver | TxOK | TxErr; static const unsigned int rtl8169_rx_config =
@@ -984,7 +987,7 @@ tp->cp_cmd = PCIMulRW | RxChkSum;if ((sizeof (dma_addr_t) >4 ) && - !pci_set_dma_mask (pdev,DMA_64BIT_MASK )) + !pci_set_dma_mask (pdev,DMA_64BIT_MASK ) && use_dac) tp->cp_cmd |=PCIDAC ;else { rc =pci_set_dma_mask (pdev,DMA_32BIT_MASK );
@@ -1760,6 +1763,15 @@if (!(status & rtl8169_intr_mask))break ; + +if (unlikely (status & SYSErr)) { + printk(KERN_ERR PFX "%s: PCI error (status: 0x%04x)." + " Device disabled.\n", dev->name, status); +RTL_W8 (ChipCmd,0x00 ); +RTL_W16 (IntrMask,0x0000 ); +RTL_R16 (IntrMask); +break ; + }if (status & LinkChg)rtl8169_check_link_status (dev, tp, ioaddr);
drivers/net/wireless/airo.c +80 -59
300 lines not on this page · raw message