Skip to contentSkip to conversation

PATCH/RFC: pci wakeup hooks (2/4)

PATCH David Brownell 1 participant 1 message Oct 4, 2004 PCI

lore
Share & tools
lore
#0 lore raw

This adds minimal PCI hooks. Maybe they should be more minimal.

This makes PCI use the new pmcore wakeup bits.

- Initialized in pci_enable_device()
- Disabled in pci_disable_device()
- Lets userspace change the initial may_wakeup policy.

Previously, wakeup policies were driver-specific (other than ethtool). This patch lets all drivers outsource such decisions.

NOTE: the init could presumably be done in probe() and never changed, except maybe when ACPI and PCI disagree. But since I (mis?)remember hearing about devices that choke on capability accesses during probe(), it's done this way instead.

ALSO: I think some boards can support system wakeup using signals other then PME# ... handling wakeup without PCI PM. Presumably board-specific logic (ACPI bytecodes?) would kick in to mark the devices appropriately; playing well with such logic might mean never clearing can_wakeup.

[ against 2.6.9-rc3 ]

drivers/pci/pci.c +15 -0
@@ -382,6 +382,16 @@
 int
 pci_enable_device(struct pci_dev *dev)
 {
+#ifdef	CONFIG_PM
+	/* with PCI PM capability, it can maybe issue PME# */
+	u16 pm = pci_find_capability(dev, PCI_CAP_ID_PM);
+	device_init_wakeup(&dev->dev, 0);
+	if (pm) {
+		pci_read_config_word(dev, pm + PCI_PM_PMC, &pm);
+		if (pm & PCI_PM_CAP_PME)
+			device_init_wakeup(&dev->dev, 1);
+	}
+#endif
 	dev->is_enabled = 1;
 	return pci_enable_device_bars(dev, (1 << PCI_NUM_RESOURCES) - 1);
 }
@@ -400,6 +410,7 @@
 	
 	dev->is_enabled = 0;
 	dev->is_busmaster = 0;
+	device_init_wakeup(&dev->dev, 0);
 
 	pci_read_config_word(dev, PCI_COMMAND, &pci_command);
 	if (pci_command & PCI_COMMAND_MASTER) {
@@ -434,6 +445,10 @@
 	 * wake events, it's a nop; otherwise fail */
 	if (!pm) 
 		return enable ? -EIO : 0; 
+
+	/* don't enable unless driver core lets us */
+	if (!device_may_wakeup(&dev->dev) && enable)
+		return -EROFS;
 
 	/* Check device's ability to generate PME# */
 	pci_read_config_word(dev,pm+PCI_PM_PMC,&value);