Skip to contentSkip to conversation

can't understand howto example

LARTC Hariett Jones 2 participants 2 messages Oct 21, 2004

lore
Share & tools
lore
#0 lore raw

tc class add dev $DEV parent 1: classid 1:1 htb rate ${UPLINK}kbit burst 6k

tc qdisc add dev $DEV handle ffff: ingress

tc filter add dev $DEV parent ffff: protocol ip prio 50 u32 match ip src \
0.0.0.0/0 police rate ${DOWNLINK}kbit burst 10k drop flowid :1

why does the download is being sent to class 1 which is limited by uplink ? why the rate is being mentioned in filter and in class ?

copied from : http://lartc.org/howto/lartc.cookbook.ultimate-tc.html#AEN2241

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 1 line · Hariett Jones

tc class add dev $DEV parent 1: classid 1:1 htb rate ${UPLINK}kbit burst 6k

This is for packets leaving device $DEV.

Quoted 4 lines

tc qdisc add dev $DEV handle ffff: ingress

tc filter add dev $DEV parent ffff: protocol ip prio 50 u32 match ip src \
0.0.0.0/0 police rate ${DOWNLINK}kbit burst 10k drop flowid :1

This is for packets entering device $DEV. "flowid :1" is an other destination as "classid 1:1" in the previous line. Read "flowid :1" as "flowid ffff:1".

Quoted 2 lines

why does the download is being sent to class 1 which is limited by uplink ? why the rate is being mentioned in filter and in class ?

For ingress, the destination is not important. It's the policer that counts and that limits the matching packets to a certain rate (${DOWNLINK}kbit in this example).

Stef

Signature · 6 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/