Skip to contentSkip to conversation

ne.c driver to support TX4927 board

PATCH New Manish Lachwani 1 participant 1 message Nov 12, 2004

Subsystems (2)
Network drivers MIPS
lore
Share & tools
lore

Manish Lachwani

author
#0 lore raw

PATCH 1/1 ne.c driver to support TX4927 board

Hi Ralf

Attached patch implements changes to the ne.c driver to support the TX4927 board. Please review

Thanks
Manish Lachwani

Source: MontaVista Software, Inc. | http://www.mvista.com | Manish Lachwani <[email protected]>
Type: Defect Fix
Disposition: Submitted to Linux-MIPS
Description:
Support for RBTX4927 in NS8390 ethernet driver in 2.6.10

drivers/net/ne.c +10 -0
Index: linux/drivers/net/ne.c
===================================================================
@@ -112,6 +112,7 @@
     {"PCM-4823", "PCM-4823", {0x00, 0xc0, 0x6c}}, /* Broken Advantech MoBo */
     {"REALTEK", "RTL8019", {0x00, 0x00, 0xe8}}, /* no-name with Realtek chip */
     {"LCS-8834", "LCS-8836", {0x04, 0x04, 0x37}}, /* ShinyNet (SET) */
+    {"RBHMA4X00-RTL8019", "RBHMA4X00/RTL8019", {0x00, 0x60, 0x0a}},  /* Toshiba built-in */
     {NULL,}
 };
 #endif

@@ -226,6 +227,10 @@
 	sprintf(dev->name, "eth%d", unit);
 	netdev_boot_setup_check(dev);
 
+#ifdef CONFIG_TOSHIBA_RBTX4927
+	dev->base_addr = 0x06020280;
+	dev->irq = 29;
+#endif
 	err = do_ne_probe(dev);
 	if (err)
 		goto out;

@@ -511,6 +516,11 @@
 	ei_status.name = name;
 	ei_status.tx_start_page = start_page;
 	ei_status.stop_page = stop_page;
+
+#ifdef CONFIG_TOSHIBA_RBTX4927	
+	wordlength = 1;
+#endif
+
 #ifdef CONFIG_PLAT_OAKS32R
 	ei_status.word16 = 0;
 #else