remove outdated OSS Changelogs (fwd)

@@ -1,213 +0,0 @@
-1998-12-04  Andrew T. Veliath  <[email protected]>
-
-	* Update version to 0.8.2.2
-
-	* Add msndreset program to shell archive.
-
-1998-11-11  Andrew T. Veliath  <[email protected]>
-
-	* msnd_pinnacle.c (mixer_ioctl): Add a mixer ioctl for
-	SOUND_MIXER_PRIVATE1 which does a full reset on the card.
-	(mixer_set): Move line in recording source to input monitor, aux
-	input level added, some mixer fixes.
-
-1998-09-10  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.8.2
-
-	* Add SNDCTL_DSP_GETOSPACE and SNDCTL_DSP_GETISPACE ioctls.
-
-1998-09-09  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.8.1
-	
-	* msnd_pinnacle.c: Fix resetting of default audio parameters. Turn
-	flush code from dsp_halt into dsp_write_flush, and use that for
-	SNDCTL_DSP_SYNC.
-
-1998-09-07  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.8.0
-
-	* Provide separate signal parameters for play and record.
-	
-	* Cleanups to locking and interrupt handling, change default
-	fifosize to 128kB.
-
-	* Update version to 0.7.15
-
-	* Interprocess full-duplex support (ie `cat /dev/dsp > /dev/dsp').
-
-	* More mutex sections for read and write fifos (read + write locks
-	added).
-
-1998-09-05  Andrew Veliath  <[email protected]>
-
-	* msnd_pinnacle.c: (chk_send_dsp_cmd) Do full DSP reset upon DSP
-	timeout (when not in interrupt; maintains mixer settings).  Fixes
-	to flushing and IRQ ref counting. Rewrote queuing for smoother
-	playback and fixed initial playback cutoff problem.
-
-1998-09-03  Andrew Veliath  <[email protected]>
-
-	* Replaced packed structure accesses with standard C equivalents.
-
-1998-09-01  Andrew Veliath  <[email protected]>
-
-	* msnd_pinnacle.c: Add non-PnP configuration to driver code, which
-	  will facilitate compiled-in operation.
-
-1998-08-29  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.7.6
-	
-	* msnd_pinnacle.c (dsp_ioctl): Add DSP_GETFMTS, change SAMPLESIZE
-	  to DSP_SETFMT.
-
-	* Update version to 0.7.5
-	
-	* Create pinnaclecfg.c and turn MultiSound doc into a shell
-	  archive with pinnaclecfg.c included.  pinnaclecfg.c can
-	  now fully configure the card in non-PnP mode, including the
-	  joystick and IDE controller.  Also add an isapnp conf
-	  example.
-
-	* Reduce DSP reset timeout from 20000 to 100
-
-1998-08-06  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.7.2
-	
-	* After A/D calibration, do an explicit set to the line input,
-	  rather than using set_recsrc
-
-1998-07-20  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.7.1
-
-	* Add more OSS ioctls
-	
-1998-07-19  Andrew Veliath  <[email protected]>
-
-	* Update doc file
-	
-	* Bring back DIGITAL1 with digital parameter to msnd_pinnacle.c
-	  and CONFIG_MSNDPIN_DIGITAL.  I'm not sure this actually works,
-	  since I find audio playback goes into a very speeded mode of
-	  operation, however it might be due to a lack of a digital
-	  source, which I don't have to test.
-
-1998-07-18  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.7.0
-
-	* Can now compile with Alan Cox' 2.0.34-modular-sound patch (so
-	  now it requires >= 2.1.106 or 2.0.34-ms) (note for 2.0.34-ms it
-	  is in the Experimental section)
-
-	* More modularization, consolidation, also some MIDI hooks
-	  installed for future MIDI modules
-
-	* Write flush
-
-	* Change default speed, channels, bit size to OSS/Free defaults
-
-1998-06-02  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.5b
-
-	* Fix version detection
-	
-	* Remove underflow and overflow resets (delay was too long)
-
-	* Replace spinlocked bitops with atomic bit ops
-
-1998-05-27  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.5a
-	
-	* Better recovery from underflow or overflow conditions
-	
-	* Fix a deadlock condition with one thread reading and the other
-	  writing
-
-1998-05-26  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.5
-	
-	* Separate reset queue functions for play and record
-
-	* Add delays in dsp_halt
-
-1998-05-24  Andrew Veliath  <[email protected]>
-
-	* Add a check for Linux >= 2.1.95
-	
-	* Remove DIGITAL1 input until I figure out how to make it work
-	
-	* Add HAVE_DSPCODEH which when not defined will load firmware from
-	  files using mod_firmware_load, then release memory after they
-	  are uploaded (requires reorganized OSS).
-
-1998-05-22  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.4c
-
-	* Hopefully fix the mixer volume problem
-
-1998-05-19  Andrew Veliath  <[email protected]>
-
-	* Add __initfuncs and __initdatas to reduce resident code size
-
-	* Move bunch of code around, remove some protos
-
-	* Integrate preliminary changes for Alan Cox's OSS reorganization
-	  for non-OSS drivers to coexist with OSS devices on the same
-	  major.  To compile standalone, must now define STANDALONE.
-
-1998-05-16  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.4b
-	
-	* Integrated older card support into a unified driver, tested on a
-	  MultiSound Classic c/o Kendrick Vargas.
-
-1998-05-15  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.4
-	
-	* Fix read/write return values
-
-1998-05-13  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.3
-
-	* Stop play gracefully
-
-	* Add busy flag
-	
-	* Add major and calibrate_signal module parameters
-	
-	* Add ADC calibration
-
-	* Add some OSS compatibility ioctls
-
-	* Add mixer record selection
-	
-	* Add O_NONBLOCK support, separate read/write wait queues
-
-	* Add sample bit size ioctl, expanded sample rate ioctl
-
-	* Playback suspension now resumes
-
-	* Use signal_pending after interruptible_sleep_on
-	
-	* Add recording, change ints to bit flags
-
-1998-05-11  Andrew Veliath  <[email protected]>
-
-	* Update version to 0.2
-
-	* Add preliminary playback support
-
-	* Use new Turtle Beach DSP code
\ No newline at end of file

230 lines not on this page · raw message