U-Boot for CSB226
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 5 lines · In message <[email protected]> you wrote:
Quoted 3 lines
This is a FAQ; please see
http://www.denx.de/twiki/bin/view/DULG/CanUBootBeConfiguredSuchThatItCanBeStartedInRAMJust one comment, maybe:
The FAQ tries to answer FAQ's, obviously, and thus must be a bit generic.
...
Quoted 7 lines
5) set the breakpoint at that address in the terminal connected to the BDI2000:
# rm 15 <address_of_fucntion> (You can also use the mon command in the gdb console) 6) Select connect target in the Insight menu 7) Now set the breakpoints as you wish and debug the target downloaded to the RAM.
First, this may work fior you, but it will not work for me. It does not work on PowerPC, and it does not work on MIPS for example. And it does not work if you have configured your BDI200 as recommended, i. e. that it works with a mostly virgin CPU.
Quoted 4 lines
Of course this assumes, that your BDI configuration file has setup memory controller correctly and you can access the RAM.
Any comments?
Yes, This is one of the many things you can do if you know what you are doing. If you don't have a clue it will just cause more problems and questions.
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de A day without sunshine is like night.