How to perform a Wireless Scan?
Quoted 7 lines · Matthias-Christian Ott
I'm currently developing the the wireless functions for the rtl8180 chipset.
There's only one problem:
I don't know how to perform a wireless scan.
How does it work?
Is there an algorithm or a GPL based driver which does this well?
Most modern wireless drivers support the scan function (airo,
hostap, orinoco v15, prism54, atmel_cs, wl3501, madwifi, ipw2x00, acx100, poldhu, at76c503, adm8211... - check my Howto).
Unfortunately, the implementation is highly dependant on the
hardware itself, and each hardware has it's own way. Chipset which are "softer" require more work. A good example of harder MAC is airo/orinoco, for softer MAC check madwifi.
Good luck...
Jean
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 33 lines · Matthias-Christian Ott
Quoted 21 lines · Jean Tourrilhes
Quoted 8 lines · Matthias-Christian Ott
I'm currently developing the the wireless functions for the rtl8180 chipset.
There's only one problem:
I don't know how to perform a wireless scan.
How does it work?
Is there an algorithm or a GPL based driver which does this well?Most modern wireless drivers support the scan function (airo,
hostap, orinoco v15, prism54,atmel_cs, wl3501, madwifi, ipw2x00, acx100, poldhu, at76c503, adm8211... - check my Howto).
Unfortunately, the implementation is highly dependant on the
hardware itself, and each hardware has it's own way. Chipset which are "softer" require more work. A good example of harder MAC is airo/orinoco, for softer MAC check madwifi.
Good luck...Quoted 10 lines
Jean
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Quoted 5 lines
Hi Jean!
Let me understand scan algorithm:
The card looks on different frequencies and channels for packages and extracts the mac of the access point?
Or am I wrong?
Some card do the scan automatically in firmware. You just need
to say "perform the scan", and after a while it will return some results. Other card don't have support for it, so you need to go on each frequency, send a probe request and look at the beacons.
A helpful hint : scanning is done for the initial association
of the card to the BSSID. If the card perform all the association by itself (just give an ESSID), it usually has an interface to perform scanning. If you have to write the code to perform all the association in the driver, then you can reuse that code to implement scanning.
Quoted 2 lines
Thanks
Matthias-Christian Ott
Good luck...
Jean