[2.6] Clean up SL811 headers
Quoted 2 lines · Kyle Moffett
The USB SL811 host has a structure stuck in
linux/usb_sl811.hAs this structure is kernel private and only used by a single piece of code,
That's very wrong ... the structure in question is the interface between the board-specific setup and the driver (as it says in the comment). A better way to put the situation is that www.kernel.org doesn't currently bundle support for a board that wires that chip into its platform_bus.
Quoted 2 lines
this patch moves it to the header file from which it is used, deleting the old one.
Here's a thought experiment for you ... do that for EVERY driver on the platform_bus, and see how quickly you get a big mess. Board support packages on 2.4 tended to take that approach; good riddance, IMO.
When you take that approach, then adding support for a new board means ** CHANGING EVERY DRIVER USED WITH THAT BOARD ** to know how the chip is set up on that particular board. IRQs, addressing, CPU and GPIO pin multiplexing, support logic ... yeech!
Better to have a single arch/XYZ/mach-ZYX/board-ABC.c file that just sets up the relevant platform devices, and the platform_data those drivers use. The board support packages should be small, mostly using standard drivers ... not be invasive monsters.
- Dave