Skip to contentSkip to conversation

greb + htb debug

LARTC Alaios 1 participant 1 message Jan 24, 2005

lore
Share & tools
lore

Alaios

author
#0 lore raw

Good morning i want to enable some debug messages concering htb and gred. The reason is that i want to see the journey of the ip packet through the 2.6 kernel from the start to finish (ethernet interface up to htb and gred classification).

In the sch_htc.c i have found the following

/* debugging support; S is subsystem, these are defined:
0 - netlink messages
1 - enqueue
2 - drop & requeue
3 - dequeue main
4 - dequeue one prio DRR part
5 - dequeue class accounting
6 - class overlimit status computation
7 - hint tree
8 - event queue
10 - rate estimator
11 - classifier
12 - fast dequeue cache

L is level; 0 = none, 1 = basic info, 2 = detailed, 3
= full
q->debug uint32 contains 16 2-bit fields one for
subsystem starting
from LSB
*/
#ifdef HTB_DEBUG
#define HTB_DBG_COND(S,L) (((q->debug>>(2*S))&3) >= L) #define HTB_DBG(S,L,FMT,ARG...) if (HTB_DBG_COND(S,L)) \

but still i don't know what should i change in order to see debug messages in my dmesg...

Also in the same file the following line exists
#define HTB_DEBUG 1 /* compile debugging support
(activated by tc tool) */

Do u know how i can use tc tool for viewing that debug messages?
Thx a lot

__________________________________
Do you Yahoo!?
Yahoo! Mail - Find what you need with new enhanced search.
http://info.mail.yahoo.com/mail_250
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/