Skip to contentSkip to conversation

block/swim_iop: replace schedule_timeout() with

PATCH New Nishanth Aravamudan 1 participant 1 message Mar 2, 2005

Subsystems (2)
Block layer Kernel janitors
lore
Share & tools
lore

Nishanth Aravamudan

author
#0 lore raw

PATCH 1/1 block/swim_iop: replace schedule_timeout() with

Hi,

Re-send of a patch from January 24, 2005, adding Jens this time.

Thanks,
Nish

Description: Change the delay logic of swimiop_eject() to use msleep_interruptible() and time_before(). Rather than depend on the number of iterations of the loop for timing accuracy, I rely on the current value of jiffies relative to a static timeout (end_jiffies).

Signed-off-by Nishanth Aravamudan <[email protected]>
drivers/block/swim_iop.c +6 -6
@@ -318,7 +318,8 @@ static void swimiop_status_update(int dr
 
 static int swimiop_eject(struct floppy_state *fs)
 {
-	int err, n;
+	int err;
+	unsigned long end_jiffies;
 	struct swim_iop_req req;
 	struct swimcmd_eject *cmd = (struct swimcmd_eject *) &req.command[0];
 

@@ -333,14 +334,13 @@ static int swimiop_eject(struct floppy_s
 		release_drive(fs);
 		return err;
 	}
-	for (n = 2*HZ; n > 0; --n) {
-		if (req.complete) break;
-		if (signal_pending(current)) {
+	end_jiffies = jiffies + 2 * HZ;
+	while (!req.complete && time_before(jiffies, end_jiffies)) {
+		msleep_interruptible(10);
+		if (signals_pending(current)) {
 			err = -EINTR;
 			break;
 		}
-		set_current_state(TASK_INTERRUPTIBLE);
-		schedule_timeout(1);
 	}
 	release_drive(fs);
 	return cmd->error;

_______________________________________________
Kernel-janitors mailing list
[email protected]
http://lists.osdl.org/mailman/listinfo/kernel-janitors