scsi/ide-scsi: use msleep()

PATCH [email protected] 1 participant 1 message Mar 6, 2005 SCSI

Share & tools

[email protected]

author

2005-03-06 22:26 UTC #0 lore raw

Use msleep() instead of schedule_timeout() to guarantee the
task delays as expected. Remove set_current_state() as it is taken care of by msleep().

Signed-off-by Nishanth Aravamudan <[email protected]>

Signed-off-by Domen Puncer <[email protected]>

---

 kj-domen/drivers/scsi/ide-scsi.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

drivers/scsi/ide-scsi.c renamed from drivers/scsi/ide-scsi.c~msleep-drivers_scsi_ide-scsi +2 -2

diff -puN drivers/scsi/ide-scsi.c~msleep-drivers_scsi_ide-scsi drivers/scsi/ide-scsi.c
@@ -46,6 +46,7 @@
 #include <linux/slab.h>
 #include <linux/ide.h>
 #include <linux/scatterlist.h>
+#include <linux/delay.h>
 
 #include <asm/io.h>
 #include <asm/bitops.h>

@@ -979,9 +980,8 @@ static int idescsi_eh_reset (struct scsi
 	/* ide_do_reset starts a polling handler which restarts itself every 50ms until the reset finishes */
 
 	do {
-		set_current_state(TASK_UNINTERRUPTIBLE);
 		spin_unlock_irq(cmd->device->host->host_lock);
-		schedule_timeout(HZ/20);
+		msleep(50);
 		spin_lock_irq(cmd->device->host->host_lock);
 	} while ( HWGROUP(drive)->handler );