Altix ioc4 serial - set hfc from ioctl
PATCH 1/2 Altix ioc4 serial - set hfc from ioctl
Allow hardware flow control to be set from an ioctl.
Signed-off-by Patrick Gefre <[email protected]>
drivers/serial/ioc4_serial.c +4 -7
@@ -1765,8 +1765,11 @@ the_port->ignore_status_mask &= ~N_DATA_READY ; } -if (cflag &CRTSCTS ) +if (cflag &CRTSCTS ) { info->flags |=ASYNC_CTS_FLOW ; + port->ip_sscr |=IOC4_SSCR_HFC_EN ; +writel (port->ip_sscr, &port->ip_serial_regs->sscr); + }else info->flags &= ~ASYNC_CTS_FLOW ;
@@ -1825,12 +1828,6 @@/* set the speed of the serial port */ ioc4_change_speed (the_port, info->tty->termios, (struct termios *)0 ); -/* enable hardware flow control - after ioc4_change_speed because -* ASYNC_CTS_FLOW is set there */ -if (info->flags &ASYNC_CTS_FLOW ) { - port->ip_sscr |=IOC4_SSCR_HFC_EN ; -writel (port->ip_sscr, &port->ip_serial_regs->sscr); - } info->flags |=UIF_INITIALIZED ;return 0 ; }
PATCH 2/2 Altix ioc4 serial - set a better timeout/threshold
Set the timeout and threshold to better values.
Signed-off-by Patrick Gefre <[email protected]>
drivers/serial/ioc4_serial.c +7 -4
@@ -1272,8 +1272,9 @@* and set the rx threshold to that amount. There are 4 chars * per ring entry, so we'll divide the number of chars that will * arrive in timeout by 4. +* So .... timeout * baud / 10 / HZ / 4, with HZ = 100. */ - threshold = timeout * port->ip_baud /10 /HZ /4 ; + threshold = timeout * port->ip_baud /4000 ;if (threshold ==0 ) threshold =1 ;/* otherwise we'll intr all the time! */
@@ -1285,8 +1286,10 @@writel (port->ip_sscr, &port->ip_serial_regs->sscr); -/* Now set the rx timeout to the given value */ - timeout = timeout *IOC4_SRTR_HZ /HZ ; +/* Now set the rx timeout to the given value +* again timeout * IOC4_SRTR_HZ / HZ +*/ + timeout = timeout *IOC4_SRTR_HZ /100 ;if (timeout >IOC4_SRTR_CNT ) timeout =IOC4_SRTR_CNT ;
@@ -1380,7 +1383,7 @@if (port->ip_tx_lowat ==0 ) port->ip_tx_lowat =1 ; -set_rx_timeout (port, port->ip_rx_timeout); +set_rx_timeout (port,2 );return 0 ; }