Skip to contentSkip to conversation

Use pci_set_dma_mask() instead of direct assignment of DMA mask

PATCH New Tobias Klauser 1 participant 1 message May 16, 2005

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Use pci_set_dma_mask() instead of direct assignment of DMA mask

The amd8111e driver directly assigns the DMA mask to the dma_mask member of the struct pci_dev instead of using pci_set_dma_mask(). This makes the call to pci_dma_supported() redundant as pci_set_dma_mask() does this check.

I do not own this device so I only compile-tested this patch.

drivers/net/amd8111e.c +4 -4
diff -urpN -X dontdiff linux-2.6.12-rc4/drivers/net/amd8111e.c linux-2.6.12-rc4~dma_mask/drivers/net/amd8111e.c
@@ -87,6 +87,7 @@ Revision History:
 #include <linux/if_vlan.h>
 #include <linux/ctype.h>	
 #include <linux/crc32.h>
+#include <linux/dma-mapping.h>
 
 #include <asm/system.h>
 #include <asm/io.h>
@@ -2002,12 +2003,11 @@ static int __devinit amd8111e_probe_one(
 	}
 
 	/* Initialize DMA */
-	if(!pci_dma_supported(pdev, 0xffffffff)){
+	if (pci_set_dma_mask(pdev, DMA_32BIT_MASK) < 0) {
 		printk(KERN_ERR "amd8111e: DMA not supported,"
 			"exiting.\n");
-		goto  err_free_reg;
-	} else
-		pdev->dma_mask = 0xffffffff;
+		goto err_free_reg;
+	}
 	
 	reg_addr = pci_resource_start(pdev, 0);
 	reg_len = pci_resource_len(pdev, 0);

_______________________________________________
Kernel-janitors mailing list
[email protected]
http://lists.osdl.org/mailman/listinfo/kernel-janitors