Skip to contentSkip to conversation

How-to disable irq4 serial ints

DISCUSSION Hufnus 1 participant 2 messages Jun 10, 2005

lore
Share & tools
lore

Hufnus

author
#0 lore raw

I am forced to use a legacy assembler serial driver that handles a special comm port device and preps data for a dos text gui.

Problem is, if the serial device on /dev/ttyS0 is receiving data and generating ints, this serial servicing tsr crashes during its init. But if the port is quiet it starts fine.

So, I ask for suggestions on ways to temporarily disable irq 4 interrupts from happening, until after this tsr starts ???

Thanks in advance
TonyB

--
__ __ _ I N C. http://www.sysdev.org

/ __|\\// __||  \  __   __          /         [email protected]
\__ \ \/\__ \||)|/ O_)\/ /        \/  System Tools / Utilities
|___/ || ___/|_ /\___|\_/        WIntel / Linux Device Drivers
author
#1 lore raw
Quoted 3 lines · On Thu, 9 Jun 2005 19:49:28 -0800 Hufnus <[email protected]> wrote:

So, I ask for suggestions on ways to temporarily disable irq 4 interrupts from happening, until after this tsr starts ???

Basically I was wondering, if masking the PIC with a 0x04 by doing I/O to port 0x21 would work in dosemu emulation or if there is a better way to do this?

TonyB

--
__ __ _ I N C. http://www.sysdev.org

/ __|\\// __||  \  __   __          /         [email protected]
\__ \ \/\__ \||)|/ O_)\/ /        \/  System Tools / Utilities
|___/ || ___/|_ /\___|\_/        WIntel / Linux Device Drivers