block/swim_iop: replace schedule_timeout() with msleep_interruptible()

PATCH In review [email protected] 1 participant 1 message Jun 21, 2005 Block layer

lore

Share & tools

lore

[email protected]

author

2005-06-21 06:15 UTC #0 lore raw

PATCH 10/12 block/swim_iop: replace schedule_timeout() with msleep_interruptible()

From: Nishanth Aravamudan <[email protected]>

Change the delay logic of swimiop_eject() to use msleep_interruptible() and time_before(). Rather than depend on the number of iterations of the loop for timing accuracy, I rely on the current value of jiffies relative to a static timeout (end_jiffies).

Signed-off-by Nishanth Aravamudan <[email protected]>

Signed-off-by Domen Puncer <[email protected]>

---
 swim_iop.c |   10 +++++-----
 1 files changed, 5 insertions(+), 5 deletions(-)

drivers/block/swim_iop.c +5 -5

Index: quilt/drivers/block/swim_iop.c
===================================================================
@@ -317,7 +317,8 @@ static void swimiop_status_update(int dr
 
 static int swimiop_eject(struct floppy_state *fs)
 {
-	int err, n;
+	int err;
+	unsigned long end_jiffies;
 	struct swim_iop_req req;
 	struct swimcmd_eject *cmd = (struct swimcmd_eject *) &req.command[0];

@@ -332,14 +333,13 @@ static int swimiop_eject(struct floppy_s
 		release_drive(fs);
 		return err;
 	}
-	for (n = 2*HZ; n > 0; --n) {
-		if (req.complete) break;
+	end_jiffies = jiffies + 2 * HZ;
+	while (!req.complete && time_before(jiffies, end_jiffies)) {
+		msleep_interruptible(10);
 		if (signal_pending(current)) {
 			err = -EINTR;
 			break;
 		}
-		current->state = TASK_INTERRUPTIBLE;
-		schedule_timeout(1);
 	}
 	release_drive(fs);
 	return cmd->error;