Skip to contentSkip to conversation

S2io: Hardware fixes

PATCH In review [email protected] 1 participant 1 message Jul 7, 2005

Subsystems (2)
Networking Network drivers
lore
Share & tools
lore

[email protected]

author
#0 lore raw

PATCH 2/12 S2io: Hardware fixes

Hi,
Below patch addresses few h/w specific issues.
1. Check for additional ownership bit on Rx path before starting Rx processing.
2. Enable only 4 PCCs(Per Context Controller) for Xframe I revisions less than 4.
3. Program Rx and Tx round robin registers depending on
no. of rings/FIFOs.
4. Tx continous interrupts is now a loadable parameter.
5. Reset the card if we get double-bit ECC errors.
6. A soft reset of XGXS being done to force a link state change has been eliminated.
7. After a reset, clear "parity error detected" bit,
PCI-X ECC status register, and PCI_STATUS bit in tx_pic_int register.
8. The error in the disabling allmulticast implementation has been rectified.
9. Leave the PCI-X parameters MMRBC, OST etc. at their BIOS/system defaults.

Signed-off-by Ravinandan Arakali <[email protected]>
Signed-off-by Raghavendra Koushik <[email protected]>

---

drivers/net/s2io-regs.h +7 -0
diff -uprN vanilla_kernel/drivers/net/s2io-regs.h linux-2.6.12-rc6/drivers/net/s2io-regs.h
@@ -62,6 +62,7 @@ typedef struct _XENA_dev_config {
 #define ADAPTER_STATUS_RMAC_REMOTE_FAULT   BIT(6)
 #define ADAPTER_STATUS_RMAC_LOCAL_FAULT    BIT(7)
 #define ADAPTER_STATUS_RMAC_PCC_IDLE       vBIT(0xFF,8,8)
+#define ADAPTER_STATUS_RMAC_PCC_FOUR_IDLE  vBIT(0x0F,8,8)
 #define ADAPTER_STATUS_RC_PRC_QUIESCENT    vBIT(0xFF,16,8)
 #define ADAPTER_STATUS_MC_DRAM_READY       BIT(24)
 #define ADAPTER_STATUS_MC_QUEUES_READY     BIT(25)

@@ -245,6 +246,7 @@ typedef struct _XENA_dev_config {
 #define STAT_TRSF_PER(n)           TBD
 #define	PER_SEC					   0x208d5
 #define	SET_UPDT_PERIOD(n)		   vBIT((PER_SEC*n),32,32)
+#define	SET_UPDT_CLICKS(val)		   vBIT(val, 32, 32)
 
 	u64 stat_addr;
 

@@ -289,6 +291,7 @@ typedef struct _XENA_dev_config {
 
 	u64 pcc_err_reg;
 #define PCC_FB_ECC_DB_ERR		vBIT(0xFF, 16, 8)
+#define PCC_ENABLE_FOUR			vBIT(0x0F,0,8)
 
 	u64 pcc_err_mask;
 	u64 pcc_err_alarm;

@@ -690,6 +693,10 @@ typedef struct _XENA_dev_config {
 #define MC_ERR_REG_MIRI_CRI_ERR_0          BIT(22)
 #define MC_ERR_REG_MIRI_CRI_ERR_1          BIT(23)
 #define MC_ERR_REG_SM_ERR                  BIT(31)
+#define MC_ERR_REG_ECC_ALL_SNG		   (BIT(6) | \
+					BIT(7) | BIT(17) | BIT(19))
+#define MC_ERR_REG_ECC_ALL_DBL		   (BIT(14) | \
+					BIT(15) | BIT(18) | BIT(20))
 	u64 mc_err_mask;
 	u64 mc_err_alarm;
drivers/net/s2io.c +331 -81

566 lines not on this page · raw message

drivers/net/s2io.h +4 -0
diff -uprN vanilla_kernel/drivers/net/s2io.h linux-2.6.12-rc6/drivers/net/s2io.h
@@ -372,6 +372,10 @@ typedef struct _RxD_t {
 #define RXD_GET_L4_CKSUM(val)   ((u16)(val) & 0xFFFF)
 
 	u64 Control_2;
+#define	THE_RXD_MARK		0x3
+#define	SET_RXD_MARKER		vBIT(THE_RXD_MARK, 0, 2)
+#define	GET_RXD_MARKER(ctrl)	((ctrl & SET_RXD_MARKER) >> 62)
+
 #ifndef CONFIG_2BUFF_MODE
 #define MASK_BUFFER0_SIZE       vBIT(0x3FFF,2,14)
 #define SET_BUFFER0_SIZE(val)   vBIT(val,2,14)