Skip to contentSkip to conversation

TBF + burst

LARTC js si 2 participants 2 messages Jul 20, 2005

lore
Share & tools
lore

js si

author
#0 lore raw

I am using tbf to do rate limitation. i set the rate, burst and latency parameters for tbf. but when i start passing data i notice that there is an initial burst and then the rate goes down to the configured level. is this because tbf starts with a full bucket?

thanks.

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc

#1 lore raw
Quoted 5 lines · js si

I am using tbf to do rate limitation. i set the rate, burst and latency parameters for tbf. but when i start passing data i notice that there is an initial burst and then the rate goes down to the configured level. is this because tbf starts with a full bucket?

Well I suppose the burst starts full.

Remember if you are looking at tc stats then they show enqueue not dequeue, so you would see the whole buffer filling, but the dequeue rate will be lower.

Andy.
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc