3/8 Move sensitive system definitions into the sub-arch layer

Index: linux-2.6.13/include/asm-i386/system.h
===================================================================
@@ -100,56 +100,8 @@
 #define savesegment(seg, value) \
 	asm volatile("mov %%" #seg ",%0":"=rm" (value))
 
-/*
- * Clear and set 'TS' bit respectively
- */
-#define clts() __asm__ __volatile__ ("clts")
-#define read_cr0() ({ \
-	unsigned int __dummy; \
-	__asm__ __volatile__( \
-		"movl %%cr0,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr0(x) \
-	__asm__ __volatile__("movl %0,%%cr0": :"r" (x));
-
-#define read_cr2() ({ \
-	unsigned int __dummy; \
-	__asm__ __volatile__( \
-		"movl %%cr2,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr2(x) \
-	__asm__ __volatile__("movl %0,%%cr2": :"r" (x));
-
-#define read_cr3() ({ \
-	unsigned int __dummy; \
-	__asm__ ( \
-		"movl %%cr3,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr3(x) \
-	__asm__ __volatile__("movl %0,%%cr3": :"r" (x));
-
-#define read_cr4() ({ \
-	unsigned int __dummy; \
-	__asm__( \
-		"movl %%cr4,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr4(x) \
-	__asm__ __volatile__("movl %0,%%cr4": :"r" (x));
-#define stts() write_cr0(8 | read_cr0())
-
 #endif	/* __KERNEL__ */
 
-#define wbinvd() \
-	__asm__ __volatile__ ("wbinvd": : :"memory");
-
 static inline unsigned long get_limit(unsigned long segment)
 {
 	unsigned long __limit;

@@ -459,15 +411,7 @@
 
 #define set_wmb(var, value) do { var = value; wmb(); } while (0)
 
-/* interrupt control.. */
-#define local_save_flags(x)	do { typecheck(unsigned long,x); __asm__ __volatile__("pushfl ; popl %0":"=g" (x): /* no input */); } while (0)
-#define local_irq_restore(x) 	do { typecheck(unsigned long,x); __asm__ __volatile__("pushl %0 ; popfl": /* no output */ :"g" (x):"memory", "cc"); } while (0)
-#define local_irq_disable() 	__asm__ __volatile__("cli": : :"memory")
-#define local_irq_enable()	__asm__ __volatile__("sti": : :"memory")
-/* used in the idle loop; sti takes one instruction cycle to complete */
-#define safe_halt()		__asm__ __volatile__("sti; hlt": : :"memory")
-/* used when interrupts are already enabled or to shutdown the processor */
-#define halt()			__asm__ __volatile__("hlt": : :"memory")
+#include <mach_system.h>
 
 #define irqs_disabled()			\
 ({					\

@@ -476,9 +420,6 @@
 	!(flags & (1<<9));		\
 })
 
-/* For spinlocks etc */
-#define local_irq_save(x)	__asm__ __volatile__("pushfl ; popl %0 ; cli":"=g" (x): /* no input */ :"memory")
-
 /*
  * disable hlt during certain critical i/o operations
  */

76 lines not on this page · raw message