question.
I tryed to install dosemu on mandrale linux 9.1. "make" run OK and "make install" too. Freedos is installed and I can run text DOS programs. But I don't know how can I use program with graphics output - classic borland C++ 3.1 program. If I run program, program runs ( I can stop it with kwyboard, but I don't see graphics output - standard 640x480 VGA ). I try this on other competer and result is the same. But on this PC some text programs don't run corectly (volkov commander), because text window is in some strange mode ( something like 100x36 not 80x25).I tryed to configure dosemu.conf file but no solution.
Could you help me?
Quoted 3 lines · s.r.o.
I tryed to install dosemu on mandrale linux 9.1. "make" run OK and "make install" too. Freedos is installed and I can run text DOS programs. But I don't know how can I use program with graphics output - classic borland C++ 3.1 program. If I run program, program runs ( I can stop it with kwyboard, but I don't see graphics output - standard 640x480 VGA ). I try this on other competer and result is the same. But on this PC some text programs don't run corectly (volkov commander), because text window is in some strange mode ( something like 100x36 not 80x25).I tryed to configure dosemu.conf file but no solution.
Could you help
How did you start dosemu? From an xterm (in X) you should use the command "xdosemu", not "dosemu", if you want graphics.
Regards, Jan
Quoted 7 lines · Jan Willem Stumpel
Quoted 3 lines · s.r.o.
I tryed to install dosemu on mandrale linux 9.1. "make" run OK and "make install" too. Freedos is installed and I can run text DOS programs. But I don't know how can I use program with graphics output
you should use the
command "xdosemu", not "dosemu", if you want graphics.
Something to be fixed on the dosemu end, perhaps, to avoid this kind of confusion?