Skip to contentSkip to conversation

2.6.14-rc3-rt10 crashes on boot

DISCUSSION Ingo Molnar 1 participant 1 message Oct 11, 2005 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 5 lines · John Rigg

Ingo, thanks to help from Steve Rostedt I got 2.6.14-rc3-rt12 to compile with CONFIG_DEBUG_STACKOVERFLOW=y on x86_64 smp. Unfortunately if I enable it along with latency tracing (which is causing the crash during boot) it crashes so early that I can't get anything from the serial console, even using earlyprintk.

i fixed this in -rc4-rt1, could you give it a try?

Ingo