Skip to contentSkip to conversation

VIA VT8251 on Asus A8V-MV

DISCUSSION Jason Cribbins 4 participants 6 messages Nov 20, 2005 – Nov 22, 2005 libata

lore
Share & tools
lore
#0 lore raw

I was wondering if its possible to find someone to create a driver support for the Via VT8251 South Bridge chipset which appears to have been around for about a year now. I am unable to get any form of Linux to see my HDs connected to that on board controller. Although I have successfully used it in non-raid mode on FreeBSD. I need this for fedora if possible.

Is something like this possible? And if so would it cost anything?

Thanks
Jason Cribbins

#1 lore raw
Quoted 8 lines · Jason Cribbins

I was wondering if its possible to find someone to create a driver support for the Via VT8251 South Bridge chipset which appears to have been around for about a year now. I am unable to get any form of Linux to see my HDs connected to that on board controller. Although I have successfully used it in non-raid mode on FreeBSD. I need this for fedora if possible.

Is something like this possible? And if so would it cost anything?

The vt8251 is supported for quite some time by the IDE driver and its vt82cxxx.c chipset driver.

Signature · 2 lines
Vojtech Pavlik
SuSE Labs, SuSE CR
#2 lore raw

Can you explain the situation in the following URL?
http://forums.viaarena.com/messageview.aspx?catid=28&threadid=68455&STARTPAGE=1

Also as I try to install fedora it reports that it is unable to find any installed HDs. I have found an OpenBSD patch that does get it to work there but nothing for Linux that works as of right now. My BIOS has the controller set to SATA mode right now and its not visible. Even if I set it to RAID mode or AHCI modes I get the same result using fedora core4 and what ever kernel comes bundled with their installer.

Quoted 15 lines · Vojtech Pavlik
Quoted 5 lines · Jason Cribbins

I was wondering if its possible to find someone to create a driver support for the Via VT8251 South Bridge chipset which appears to have been around for about a year now. I am unable to get any form of Linux to see my HDs connected to that on board controller. Although I have successfully used it in non-raid mode on FreeBSD. I need this for fedora if possible.

Is something like this possible? And if so would it cost anything?

The vt8251 is supported for quite some time by the IDE driver and its vt82cxxx.c chipset driver.

#3 lore raw
Quoted 10 lines · Jason Cribbins

Can you explain the situation in the following URL?
http://forums.viaarena.com/messageview.aspx?catid=28&threadid=68455&STARTPAGE=1

Also as I try to install fedora it reports that it is unable to find any installed HDs. I have found an OpenBSD patch that does get it to work there but nothing for Linux that works as of right now.
My BIOS has the controller set to SATA mode right now and its not visible. Even if I set it to RAID mode or AHCI modes I get the same result using fedora core4 and what ever kernel comes bundled with their installer.

The AHCI driver certainly won't work without adding PCI IDs to it...

did you try that?

These threads seem to indicate that AHCI needs updating for VIA.

Jeff

#4 lore raw
Quoted 13 lines · Jeff Garzik <jgarzik <at> pobox.com> writes:
Quoted 10 lines · Jason Cribbins

Can you explain the situation in the following URL?
http://forums.viaarena.com/messageview.aspx?catid=28&threadid=68455

Also as I try to install fedora it reports that it is unable to find any installed HDs. I have found an OpenBSD patch that does get it to work there but nothing for Linux that works as of right now.
My BIOS has the controller set to SATA mode right now and its not visible. Even if I set it to RAID mode or AHCI modes I get the same result using fedora core4 and what ever kernel comes bundled with their installer.

Quoted 7 lines

The AHCI driver certainly won't work without adding PCI IDs to it...

did you try that?

These threads seem to indicate that AHCI needs updating for VIA.

Jeff

I hate to spoil the suspense but I imagine you will meet with the same results others have. There have been a few posts to this list regarding the chipset and so far no concrete ideas about what may be going on. The following will patch your ahci.c file to provide the correct PCI ID and, if my experience holds, the chip will be recognized but communicating with the drives will timeout.

ahci.c 2005-11-21 21:52:41.000000000 -0500 renamed from ahci.c 2005-11-21 21:52:38.000000000 -0500 +2 -0
@@ -277,6 +277,8 @@
          board_ahci }, /* ESB2 */
        { PCI_VENDOR_ID_INTEL, 0x27c6, PCI_ANY_ID, PCI_ANY_ID, 0, 0,
          board_ahci }, /* ICH7-M DH */
+       { PCI_VENDOR_ID_VIA, 0x3349, PCI_ANY_ID, PCI_ANY_ID, 0, 0,
+         board_ahci }, /* VT8251 */
        { }     /* terminate list */
 };
 

Best of luck and please post your results of adding this ID to the AHCI driver.

Andrew

#5 lore raw
In reply to Jason Cribbins
Quoted 10 lines · Jason Cribbins

Can you explain the situation in the following URL?
http://forums.viaarena.com/messageview.aspx?catid=28&threadid=68455&STARTPAGE=1

Also as I try to install fedora it reports that it is unable to find any installed HDs. I have found an OpenBSD patch that does get it to work there but nothing for Linux that works as of right now.
My BIOS has the controller set to SATA mode right now and its not visible. Even if I set it to RAID mode or AHCI modes I get the same result using fedora core4 and what ever kernel comes bundled with their installer.

I'm sorry, I confused it with the vt8231.

Quoted 17 lines
Quoted 15 lines · Vojtech Pavlik
Quoted 8 lines · Jason Cribbins

I was wondering if its possible to find someone to create a driver support for the Via VT8251 South Bridge chipset which appears to have been around for about a year now. I am unable to get any form of Linux to see my HDs connected to that on board controller. Although I have successfully used it in non-raid mode on FreeBSD. I need this for fedora if possible.

Is something like this possible? And if so would it cost anything?

The vt8251 is supported for quite some time by the IDE driver and its vt82cxxx.c chipset driver.

Signature · 2 lines
Vojtech Pavlik
SuSE Labs, SuSE CR