SMART over USB - problem
SMART over USB - problem
usb--------------------------------------------------------
# smartctl -a -T verypermissive /dev/sde smartctl version 5.33 Copyright (C) 2002-4 Bruce Allen Home page is http://smartmontools.sourceforge.net/
Device: WDC WD25 00JB-00GVA0 Version: 08.0
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
Quoted 1 line
Quoted 1 line
Terminate command early due to bad response to IEC mode page
Error Counter logging not supported
Error Events logging not supported
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0 Device does not support Self Test logging
# smartctl -a -T verypermissive /dev/sdd smartctl version 5.33 Copyright (C) 2002-4 Bruce Allen Home page is http://smartmontools.sourceforge.net/
Device: WDC WD30 00JB-00KFA0 Version: 08.0
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0
Quoted 1 line
Quoted 1 line
Terminate command early due to bad response to IEC mode page
Error Counter logging not supported
Error Events logging not supported
scsiModePageOffset: response length too short, resp_len=4 offset=4 bd_len=0 Device does not support Self Test logging
ide----------------------------------------------------------
# smartctl -a -T verypermissive /dev/hda smartctl version 5.33 Copyright (C) 2002-4 Bruce Allen Home page is http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Device Model: WDC WD1200BB-22CAA0 Serial Number: WD-WMA8Cxxxxxxx Firmware Version: 16.06V16 User Capacity: 120,034,123,776 bytes Device is: In smartctl database [for details use: -P show] ATA Version is: 5 ATA Standard is: Exact ATA specification draft version not indicated Local Time is: Thu Dec 1 14:17:57 2005 CST SMART support is: Available - device has SMART capability. SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error. Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever been run.
Total time to complete Offline
data collection: (4680) seconds.
Offline data collection
capabilities: (0x3b) SMART execute Offline immediate.
Auto Offline data collection on/off supp ort. Suspend Offline collection upon new command.
Offline surface scan supported. Self-test supported.
Conveyance Self-test supported. No Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 87) minutes.
Conveyance self-test routine
recommended polling time: ( 5) minutes.
SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_ FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 200 200 051 Pre-fail Always - 0 3 Spin_Up_Time 0x0007 099 091 021 Pre-fail Always - 5841 4 Start_Stop_Count 0x0032 100 100 040 Old_age Always - 708 5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail Always - 0 7 Seek_Error_Rate 0x000b 200 200 051 Pre-fail Always - 0 9 Power_On_Hours 0x0032 086 086 000 Old_age Always - 10517 10 Spin_Retry_Count 0x0013 100 100 051 Pre-fail Always - 0 11 Calibration_Retry_Count 0x0013 100 100 051 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 686 196 Reallocated_Event_Count 0x0032 200 200 000 Old_age Always - 0 197 Current_Pending_Sector 0x0012 200 200 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0012 200 200 000 Old_age Always - 0 199 UDMA_CRC_Error_Count 0x000a 200 253 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x0009 200 200 051 Pre-fail Offline - 0
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
No self-tests have been logged. [To run self-tests, use: smartctl -t]
Device does not support Selective Self Tests/Logging #
-----------------------------------------------------------------------
ide---works
usb---not
(USB-external-case) or (eide-usb-scsi conversion) ???
xboom
Quoted 1 line · art
SMART over USB - problem
Do you expect it to work? USB storage is really scsi, so I doubt this will ever work like you are expecting it to.
sorry,
greg k-h