w1 : change data type, move code,
cover w1 : change data type, move code,
This three-part series does the following:
1. Change the type 'unsigned long' member of 'struct w1_bus_master' to 'void *'
2. Move w1 bus master code into 'w1/masters' and move w1 slave code into 'w1/slaves'
3. Add the DS2482 I2C-to-w1 bridge driver
Signed-off-by Ben Gardner <bgardner at wabtec.com>
cover w1 : change data type, move code,
Quoted 7 lines · Ben Gardner (gardner.ben at gmail.com)
This three-part series does the following:
1. Change the type 'unsigned long' member of 'structw1_bus_master' to 'void *'
2. Move w1 bus master code into 'w1/masters' and move w1 slave code into 'w1/slaves'
3. Add the DS2482 I2C-to-w1 bridge driverSigned-off-by Ben Gardner <bgardner at wabtec.com>
I will take a look tomorrow and if there are no problems will push it upstrem.
Thank you.
Signature · 1 line
Evgeniy Polyakov