Problems with longhaul on a C3 (epia ME6000, MII6000 and 800) all non nehemiah core
I have left a post on VIA forums "http://forums.viaarena.com/messageview.aspx?catid=28&threadid=67875&enterthread=y"
regarding this for a long time and got no answer.
Becoming more and mode desparate for help I started looking for emails on the source code and documentation; this is why I'm writing to you.
After longhaul module loading everything seems to be woorking fine.
I can doo all one would expect in the /sys fs, problems rise later:
I left my EPIA 800 running at lowest possible frequency for some time (399MHz with userspace governor).
Apparently everything was working but after some time (something in the order of one hour) the system froze irreparably. Screen went blank and mouse/keyboard activity does not light it again (brobably because the system is totally hung).
I'ts not a one off problem because I have ben able to reproduce the problem on all my VIA mini-itx boards.
I did a little more investigation on the matter and found this:
It only happens wheni I insert the longhaul module (I've had my boards running for days without locking up when the longhaul module is not loaded), I've reproduced the problem on EPIA 800, M6000 and MII6000,
I've reproduced the problem bothe in high and low cpu load,
I've been monitoring the cpu temperature with external sensor that supprisingly reports that the temperature shoots up after the freeze,
I have not changet power supply and/or cooling system, I've reproduced the problem on 2.6.12.x and 2.6.13 kernels (all unpatched),
I've upgraded the bios on all my boards to get the "via 2 slot pci raiser card" working (but I'm not currently using it).
Meantime I came across a XP-M based laptop ... powernow-k7 works fine without the freeze after some time.
So I decided to google a little mor on this and found this on http://www.cpqlinux.com/acpi-howto.html
Quoted 3 lines
Hang Recovery
Recovering from a GUI hard lock up:
If you get no feedback either from the keyboard or
monitor, then to >recover you should:
Quoted 1 line
1. if your network is up, then ssh/rsh/telnet into
your box and tell it to >reboot
Quoted 1 line
2. if network is not up, then try this key sequence:
CTRL+ALT+F1 >CTRL+ALT+DEL. You will not get any video
Quoted 2 lines
or keyboard feedback but this
_MAY_ blindly switch to tty1 (CTRL+ALT+F1) and press
ing CTRL+ALT+DEL >_MAY_ cause your system to do a polite reboot rather than a hard shutdown, >then wait an appropriate amount
Quoted 2 lines
of time that it usually takes to reboot
your machine
This is describing some problems that can arise when acpi manipulates cpu frequency on certain power state transitions and actually I'm using acpi on all the systems that produce the problem.
Any idea as to why ?
Any hope for a fix ?
Regards
David
Chiacchiera con i tuoi amici in tempo reale!
http://it.yahoo.com/mail_it/foot/*http://it.messenger.yahoo.com