8TB logical volumes with LVM2
Hello folks,
I'm trying to configure a system with 2 12 port 3ware 9550SX SATA RAID cards to join the two physical volumes exported by the cards into a single logical volume. There are 24x400GB drives, so the total is just above 8TB.
After running the following commands:
pvcreate --metadatasize 1024 /dev/sdb1
pvcreate --metadatasize 1024 /dev/sdc1
vgcreate -s 128M vg0 /dev/sdb1 /dev/sdc1
lvcreate -n lv0 -L8T vg0
The lvcreate command gobbles up CPU and memory as would be expected, however, I get the following error message:
device-mapper device too small for target: /dev/sdb1 device mapper ioctl cmd 9 failed: Invalid argument. could not load device vg0-lv0
failed to activate new LV
Am I doing something incorrectly? I've tried with both Fedora Core 3 and Fedora Core 4. Any pointers on how I should continue with this would be greatly appreciated.
Kind regards,
Devon H. O'Dell
Quoted 6 lines · Devon H. O'Dell
Hello folks,
I'm trying to configure a system with 2 12 port 3ware 9550SX SATA RAID cards to join the two physical volumes exported by the cards into a single logical volume. There are 24x400GB drives, so the total is just above 8TB.
I did pretty much the same thing on a Caos Linux system with two twelve-port 3ware 9000 SATA raid and twenty-four 250 GB disks, creating one big 6.6T file system. No problems to report from here. You did make GPT labels on the two SCSI devices, didn't you?
David S.
Quoted 29 lines
After running the following commands:
pvcreate --metadatasize 1024
/dev/sdb1
pvcreate --metadatasize 1024/dev/sdc1
vgcreate -s 128M vg0/dev/sdb1/dev/sdc1
lvcreate -n lv0 -L8T vg0The lvcreate command gobbles up CPU and memory as would be expected, however, I get the following error message:
device-mapper device too small for target:
/dev/sdb1device mapper ioctl cmd 9 failed: Invalid argument. could not load device vg0-lv0
failed to activate new LVAm I doing something incorrectly? I've tried with both Fedora Core 3 and Fedora Core 4. Any pointers on how I should continue with this would be greatly appreciated.
Kind regards,
Devon H. O'Dell
_______________________________________________
linux-lvm mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
2006/1/24, DGS <[email protected]>:
Quoted 8 lines · Devon H. O'Dell
Quoted 6 lines
Hello folks,
I'm trying to configure a system with 2 12 port 3ware 9550SX SATA RAID cards to join the two physical volumes exported by the cards into a single logical volume. There are 24x400GB drives, so the total is just above 8TB.
Quoted 7 lines
I did pretty much the same thing on a Caos Linux system with two twelve-port 3ware 9000 SATA raid and twenty-four 250 GB disks, creating one big 6.6T file system. No problems to report from here. You did make GPT labels on the two SCSI devices, didn't you?
David S.
Apparently not. I've got it now; I did indeed need to create the GPT labels. Thanks for the reminder; I appreciate it.
--Devon