Skip to contentSkip to conversation

raidautorun gets ENODEV when called from initrd in 2.6.15.4

DISCUSSION Alain Fauconnet 1 participant 1 message Mar 14, 2006

lore
Share & tools
lore
#0 lore raw

Hello readers,

Would someone please hint me on why a box using SATA (sata_sil - wouldn't think it's relevant) and software RAID-1 can't boot with RAID support as modules? (using an initrd image).

I get "raidautorun: RAID_AUTORUN failed: 19" when nash runs "raidautorun /dev/md0" at boot, therefore the root filesystem fails to mount and the system panics. At this point I have confirmed that the physical member devices/partitions have been detected OK and that the md-mod.ko and raid1.ko modules load without error.

The same box boots OK with RAID support compiled static, but well, I like the dynamic way and I'd love to understand what's going on.

Quoted 1 line

From what I can see (confirmed by adding a "printk" there),

that part of md.c is hit:

        /* if we are not initialised yet, only ADD_NEW_DISK, STOP_ARRAY,
         * RUN_ARRAY, and SET_BITMAP_FILE are allowed */
        if (!mddev->raid_disks && cmd != ADD_NEW_DISK && cmd != STOP_ARRAY
                        && cmd != RUN_ARRAY && cmd != SET_BITMAP_FILE) {
                printk(KERN_ALERT "md: cmd = %d\n", cmd); /* added by me */
                err = -ENODEV; 
                goto abort_unlock;

The IOCTL command received is 0x914 (RAID_AUTORUN) which makes sense to me. So the issue is that mddev->raid_disks is NULL, I guess.

Trustix Linux 2.2
Kernel 2.6.15.4 compiled from source
Mkinitrd 4.1.18-2 RPM from FC3 installed in place
of the original one that comes with Trustix because it can't manage .ko modules.
The same setup works on a Dell Poweredge 750 in an almost exacty similar configuration (2 SATA disks - Intel chipset in this case, with software RAID, kernel 2.6.13).

I'm stuck. I'd be very grateful to receive any hint.

Greets,
_Alain_