Skip to contentSkip to conversation

Tricky advice needed: copy value of an environment variable into ram

U-Boot-Users Matthias Fuchs 2 participants 2 messages Mar 17, 2006

lore
Share & tools
lore
#0 lore raw

Hi,

I need an idea on how to copy the value of an environment variable into RAM.

Let's say serial#=ABC1234, then I want to get ABC1234 into RAM at address 0x100000. Is this possible with some tricky u-boot commands?

It the PMC405 target where I want to do this and hopefully without modification to the u-boot configuration.

Matthias

#1 lore raw
Quoted 2 lines · In message <[email protected]> you wrote:

I need an idea on how to copy the value of an environment variable into RAM.

All environment ariables are already stored in RAM when U-Boot is running.

Quoted 2 lines

Let's say serial#=ABC1234, then I want to get ABC1234 into RAM at address 0x100000. Is this possible with some tricky u-boot commands?

Ah! you mean, you want to have the copy on a specific address :-)

I'm afraid there is no way to do this. We don;t have a comand that takes a strin on input and stores it to a specific address, and we don't have enough of shell tools to split and convert to hex either.

You probaly will have to to implement the "mw.s" (memory write string) command...

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
No one may kill a man.  Not for any purpose.  It cannot be condoned.
	-- Kirk, "Spock's Brain", stardate 5431.6