Skip to contentSkip to conversation

s390: qeth :allow setting of attribute "route6" to "no_router".

PATCH In review Frank Pavlic 1 participant 1 message Mar 22, 2006

Subsystems (4)
lore
Share & tools
lore
#0 lore raw

PATCH 4/6 s390: qeth :allow setting of attribute "route6" to "no_router".

[patch 4/6] s390: qeth :allow setting of attribute "route6" to "no_router".

From: Ursula Braun <[email protected]>
when setting route6 attribute back to no_router qeth does not issue an IP ASSIST command to reset router value to no_router. Once primary_router is set device stays in this mode. Issue an IP ASSIST command when no_router is set in route6. Device will be reset and thus will not longer run as a primary router.

diffstat:

 qeth_main.c |    5 -----
 1 files changed, 5 deletions(-)
drivers/s390/net/qeth_main.c +0 -5
index 69329ea..021cd5d 100644
@@ -7339,11 +7339,6 @@ qeth_setrouting_v6(struct qeth_card *car
 	qeth_correct_routing_type(card, &card->options.route6.type,
 				  QETH_PROT_IPV6);
 
-	if ((card->options.route6.type == NO_ROUTER) ||
-	    ((card->info.type == QETH_CARD_TYPE_OSAE) &&
-	     (card->options.route6.type == MULTICAST_ROUTER) &&
-	     !qeth_is_supported6(card,IPA_OSA_MC_ROUTER)))
-		return 0;
 	rc = qeth_send_setrouting(card, card->options.route6.type,
 				  QETH_PROT_IPV6);
 	if (rc) {