2.6.17-rc3 PCI init hang
I have a dual Pentium III I use for testing. Since late last week (around about 2.6.17-rc3) it hangs during boot just after "Setting up standard PCI resources". 2.6.17-rc2 works fine.
A push in the right direction would be appreciated. Please reply off list as I'm not subscribed.
...
PCI: PCI BIOS revision 2.10 entry at 0xfdbc1, last bus=1 Setting up standard PCI resources
Quoted 2 lines
Quoted 2 lines
Quoted 2 lines
2.6.17-rc3 stops here and hangs.
2.6.17-rc2 continues with:
PCI: Probing PCI hardware
PCI: Discovered peer bus 01
PCI: Using IRQ router ServerWorks [1166/0200] at 0000:00:0f.0 PCI->APIC IRQ transform: 0000:00:03.0[A] -> IRQ 31 PCI->APIC IRQ transform: 0000:01:03.0[A] -> IRQ 23
PCI: Cannot allocate resource region 0 of device 0000:00:0f.2
...
lspci -v:
00:00.0 Host bridge: Broadcom CNB20LE Host Bridge (rev 06)
Flags: bus master, medium devsel, latency 32
00:00.1 Host bridge: Broadcom CNB20LE Host Bridge (rev 06)
Flags: bus master, medium devsel, latency 16
00:01.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc Rage XL
Flags: bus master, stepping, medium devsel, latency 64
Memory at fd000000 (32-bit, non-prefetchable) [size=16M]
I/O ports at d800 [size=256]
Memory at feaff000 (32-bit, non-prefetchable) [size=4K]
Expansion ROM at feac0000 [disabled] [size=128K]
Capabilities: <available only to root>
00:03.0 RAID bus controller: Promise Technology, Inc. PDC20267 (FastTrak100/Ultra100) (rev 02)
Subsystem: Promise Technology, Inc.: Unknown device 4d32
Flags: bus master, medium devsel, latency 64, IRQ 31
I/O ports at dfe0 [size=8]
I/O ports at dfac [size=4]
I/O ports at dfa0 [size=8]
I/O ports at dfa8 [size=4]
I/O ports at df00 [size=64]
Memory at feaa0000 (32-bit, non-prefetchable) [size=128K]
Expansion ROM at feae0000 [size=64K]
Capabilities: <available only to root>
00:0f.0 ISA bridge: Broadcom OSB4 South Bridge (rev 50)
Subsystem: Broadcom OSB4 South Bridge
Flags: bus master, medium devsel, latency 0
00:0f.1 IDE interface: Broadcom OSB4 IDE Controller (prog-if 8a [Master SecP PriP])
Flags: bus master, medium devsel, latency 64
I/O ports at ffa0 [size=16]
00:0f.2 USB Controller: Broadcom OSB4/CSB5 OHCI USB Controller (rev 04) (prog-if 10 [OHCI])
Subsystem: Broadcom OSB4/CSB5 OHCI USB Controller
Flags: medium devsel
Memory at 30000000 (32-bit, non-prefetchable) [size=4K]
01:03.0 Ethernet controller: Netgear GA630 Gigabit Ethernet (rev 01)
Subsystem: Netgear GA630 Gigabit Ethernet
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 23 Memory at febfc000 (32-bit, non-prefetchable) [size=16K]
Signature · 2 lines
corporate: <cel at netapp dot com> personal: <chucklever at bigfoot dot com>
Quoted 3 lines · On Mon, 01 May 2006 15:04:25 -0400 Chuck Lever <[email protected]> wrote:
I have a dual Pentium III I use for testing. Since late last week (around about 2.6.17-rc3) it hangs during boot just after "Setting up standard PCI resources". 2.6.17-rc2 works fine.
Bummer
Quoted 3 lines
A push in the right direction would be appreciated. Please reply off list as I'm not subscribed.
Is there any chance you can do a git-bisect to find the bad patch?
Quoted 75 lines
...
PCI: PCI BIOS revision 2.10 entry at
0xfdbc1, last bus=1 Setting up standard PCI resourcesQuoted 2 lines
Quoted 2 lines
Quoted 2 lines
2.6.17-rc3 stops here and hangs.
2.6.17-rc2 continues with:PCI: Probing PCI hardware
PCI: Discovered peer bus 01
PCI: Using IRQ router ServerWorks [1166/0200] at 0000:00:0f.0PCI->APICIRQ transform: 0000:00:03.0[A] -> IRQ 31PCI->APICIRQ transform: 0000:01:03.0[A] -> IRQ 23
PCI: Cannot allocate resource region 0 of device 0000:00:0f.2
...lspci -v:
00:00.0 Host bridge: Broadcom CNB20LE Host Bridge (rev 06)
Flags: bus master, medium devsel, latency 3200:00.1 Host bridge: Broadcom CNB20LE Host Bridge (rev 06)
Flags: bus master, medium devsel, latency 1600:01.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27) (prog-if 00 [VGA])
Subsystem: ATI Technologies Inc Rage XL
Flags: bus master, stepping, medium devsel, latency 64 Memory atfd000000(32-bit, non-prefetchable) [size=16M] I/O ports at d800 [size=256]
Memory atfeaff000(32-bit, non-prefetchable) [size=4K] Expansion ROM atfeac0000[disabled] [size=128K]
Capabilities: <available only to root>00:03.0 RAID bus controller: Promise Technology, Inc. PDC20267 (FastTrak100/Ultra100) (rev 02)
Subsystem: Promise Technology, Inc.: Unknown device 4d32
Flags: bus master, medium devsel, latency 64, IRQ 31 I/O ports at dfe0 [size=8]
I/O ports at dfac [size=4]
I/O ports at dfa0 [size=8]
I/O ports at dfa8 [size=4]
I/O ports at df00 [size=64]
Memory atfeaa0000(32-bit, non-prefetchable) [size=128K] Expansion ROM atfeae0000[size=64K]
Capabilities: <available only to root>00:0f.0 ISA bridge: Broadcom OSB4 South Bridge (rev 50)
Subsystem: Broadcom OSB4 South Bridge
Flags: bus master, medium devsel, latency 000:0f.1 IDE interface: Broadcom OSB4 IDE Controller (prog-if 8a [Master SecP PriP])
Flags: bus master, medium devsel, latency 64
I/O ports at ffa0 [size=16]00:0f.2 USB Controller: Broadcom OSB4/CSB5 OHCI USB Controller (rev 04) (prog-if 10 [OHCI])
Subsystem: Broadcom OSB4/CSB5 OHCI USB Controller
Flags: medium devsel
Memory at 30000000 (32-bit, non-prefetchable) [size=4K]01:03.0 Ethernet controller: Netgear GA630 Gigabit Ethernet (rev 01)
Subsystem: Netgear GA630 Gigabit Ethernet
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 23 Memory atfebfc000(32-bit, non-prefetchable) [size=16K]Signature · 7 lines
corporate: <cel at netapp dot com> personal: <chucklever at bigfoot dot com> - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
Quoted 6 lines · Andrew Morton
Quoted 1 line · On Mon, 01 May 2006 15:04:25 -0400 Chuck Lever <[email protected]> wrote:
I have a dual Pentium III I use for testing. Since late last week (around about 2.6.17-rc3) it hangs during boot just after "Setting up standard PCI resources". 2.6.17-rc2 works fine.
Bummer
Strange (but different) behavior also seen on a PE2650.
Quoted 4 lines
Quoted 2 lines
A push in the right direction would be appreciated. Please reply off list as I'm not subscribed.
Is there any chance you can do a git-bisect to find the bad patch?
Done. The bad patch was Badari's first vectored I/O patch. Removing the patch fixes the badness on both systems. I reported this to Badari late yesterday afternoon.
He hasn't seen this behavior in his test environment, which is only ppc64 and amd64.
Signature · 2 lines
corporate: <cel at netapp dot com> personal: <chucklever at bigfoot dot com>
Quoted 5 lines · In article <[email protected]> you wrote:
Newsgroups: gmane.linux.kernel
I have a dual Pentium III I use for testing. Since late last week (around about 2.6.17-rc3) it hangs during boot just after "Setting up standard PCI resources". 2.6.17-rc2 works fine.
Same situation, random hung when apply quirk_usb_early_handoff. Intel SCB2 board, dual PIII, 2Gb memory.
Quoted 2 lines
A push in the right direction would be appreciated. Please reply off list as I'm not subscribed.
Try compile USB stuff as modules or without it.
For me 2.6.16.9 kernel with CONFIG_USB=m works.
Quoted 16 lines
...
PCI: PCI BIOS revision 2.10 entry at
0xfdbc1, last bus=1 Setting up standard PCI resourcesQuoted 2 lines
Quoted 2 lines
Quoted 2 lines
2.6.17-rc3 stops here and hangs.
2.6.17-rc2 continues with:PCI: Probing PCI hardware
PCI: Discovered peer bus 01
PCI: Using IRQ router ServerWorks [1166/0200] at 0000:00:0f.0PCI->APICIRQ transform: 0000:00:03.0[A] -> IRQ 31PCI->APICIRQ transform: 0000:01:03.0[A] -> IRQ 23
PCI: Cannot allocate resource region 0 of device 0000:00:0f.2
...
Quoted 1 line
lspci -v:
[skipp]
Quoted 5 lines
00:0f.2 USB Controller: Broadcom OSB4/CSB5 OHCI USB Controller (rev 04) (prog-if 10 [OHCI])
Subsystem: Broadcom OSB4/CSB5 OHCI USB Controller
Flags: medium devsel
Memory at 30000000 (32-bit, non-prefetchable) [size=4K]
0000:00:0f.2 USB Controller: Broadcom OSB4/CSB5 OHCI USB Controller (rev 05) (prog-if 10 [OHCI])
Subsystem: Intel Corporation: Unknown device 340f
Flags: bus master, medium devsel, latency 64, IRQ 10
Memory at fea40000 (32-bit, non-prefetchable) [size=4K]
00: 66 11 20 02 17 00 80 02 05 10 03 0c 08 40 00 00
10: 00 00 a4 fe 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 86 80 0f 34
30: 00 00 00 00 00 00 00 00 00 00 00 00 0a 01 00 50