Skip to contentSkip to conversation

2.6.17-rc6 Section mismatch warnings

DISCUSSION Barry Scott 2 participants 6 messages Jun 8, 2006 – Jun 12, 2006

lore
Share & tools
lore
#0 lore raw

When I built 2.6.17-rc6 I see a lot of warnings after the MODPOST message about Section mismatch. What did I do wrong in building the kernel and modules?

I used these commands to build 2.6.17-rc6 on FC4:

$ tar xjf ~/Downloads/linux-2.6.16.tar.bz2
$ mv linux-2.6.16  linux-2.6.17-rc6
$ cd linux-2.6.17-rc6
$ bzcat ~/Downloads/patch-2.6.17-rc6.bz2| patch -p1
$ cp /boot/config-2.6.16-1.2096_FC4 ~/KernelBuild/obj/linux-2.6.17-rc6/.config
$ make O=~/KernelBuild/obj/linux-2.6.17-rc6 silentoldconfig
(took the defaults for all new config items)
$ make O=~/KernelBuild/obj/linux-2.6.17-rc6 >make-1.log 2>&1
$ make O=~/KernelBuild/obj/linux-2.6.17-rc6 modules >make-2.log 2>&1

Here are some of the warnings:

MODPOST
WARNING: drivers/input/misc/wistron_btns.o - Section mismatch: reference to .init.text:dmi_matched from .data between 'dmi_ids' (at offset 0x120) and 'keymap_aopen_1559as'
...
WARNING: drivers/isdn/hisax/hisax.o - Section mismatch: reference to .init.text:setup_teles0 from .text between 'checkcard' (at offset 0x11a5) and 'hisax_register'
...
WARNING: drivers/net/3c501.o - Section mismatch: reference to .init.text:el1_probe from .text between 'init_module' (at offset 0x146) and 'el_reset'
WARNING: drivers/net/3c503.o - Section mismatch: reference to .init.data: from .text between 'init_module' (at offset 0x47c) and 'el2_block_output'
WARNING: drivers/net/3c503.o - Section mismatch: reference to .init.data: from .text between 'init_module' (at offset 0x485) and 'el2_block_output'
...
WARNING: drivers/net/wd.o - Section mismatch: reference to .init.text: from .text after 'init_module' (at offset 0x47d)
WARNING: drivers/scsi/megaraid/megaraid_mbox.o - Section mismatch: reference to .init.text: from .text between 'megaraid_probe_one' (at offset 0x1f00) and 'megaraid_queue_command'
WARNING: drivers/video/aty/atyfb.o - Section mismatch: reference to .init.data: from .text between 'atyfb_pci_probe' (at offset 0x297f) and 'atyfb_set_par'
WARNING: drivers/video/aty/atyfb.o - Section mismatch: reference to .init.text:aty_init_cursor from .text between 'atyfb_pci_probe' (at offset 0x2dc1) and 'atyfb_set_par'
WARNING: drivers/video/macmodes.o - Section mismatch: reference to .init.text:mac_find_mode from __ksymtab between '__ksymtab_mac_find_mode' (at offset 0x0) and '__ksymtab_mac_map_monitor_sense'
WARNING: fs/jffs2/jffs2.o - Section mismatch: reference to .init.text:jffs2_zlib_init from .text between 'jffs2_compressors_init' (at offset 0x81) and 'jffs2_compressors_exit'
WARNING: sound/isa/sb/snd-sbawe.o - Section mismatch: reference to .init.text:snd_emu8000_new from .text between 'snd_sb16_probe' (at offset 0x440) and 'snd_sb16_nonpnp_remove'
WARNING: sound/isa/snd-opl3sa2.o - Section mismatch: reference to .init.text: from .text between 'snd_opl3sa2_pnp_cdetect' (at offset 0xe61) and 'snd_opl3sa2_pnp_detect'
WARNING: sound/isa/snd-opl3sa2.o - Section mismatch: reference to .init.text: from .text between 'snd_opl3sa2_pnp_detect' (at offset 0xf52) and 'snd_opl3sa2_put_single'

Barry

#1 lore raw
Quoted 3 lines · On Thu, 08 Jun 2006 12:09:46 +0100 Barry Scott wrote:

When I built 2.6.17-rc6 I see a lot of warnings after the MODPOST message about Section mismatch. What did I do wrong in building the kernel and modules?

Nothing (well, I would use "make all" instead of the last 2 commands and I would use ketchup or
http://www.xenotime.net/linux/scripts/grab-kernel-rc
to optionally download and create new kernel dirs. :)

I'll look at the warnings. Some of them are noise/bogus, I expect...

Quoted 52 lines

I used these commands to build 2.6.17-rc6 on FC4:

$ tar xjf ~/Downloads/linux-2.6.16.tar.bz2
$ mv linux-2.6.16  linux-2.6.17-rc6
$ cd linux-2.6.17-rc6
$ bzcat ~/Downloads/patch-2.6.17-rc6.bz2| patch -p1
$ cp /boot/config-2.6.16-1.2096_FC4 
~/KernelBuild/obj/linux-2.6.17-rc6/.config
$ make O=~/KernelBuild/obj/linux-2.6.17-rc6 silentoldconfig
(took the defaults for all new config items)
$ make O=~/KernelBuild/obj/linux-2.6.17-rc6 >make-1.log 2>&1
$ make O=~/KernelBuild/obj/linux-2.6.17-rc6 modules >make-2.log 2>&1

Here are some of the warnings:

MODPOST
WARNING: drivers/input/misc/wistron_btns.o - Section mismatch: reference to .init.text:dmi_matched from .data between 'dmi_ids' (at offset 0x120) and 'keymap_aopen_1559as'
...
WARNING: drivers/isdn/hisax/hisax.o - Section mismatch: reference to .init.text:setup_teles0 from .text between 'checkcard' (at offset 0x11a5) and 'hisax_register'
...
WARNING: drivers/net/3c501.o - Section mismatch: reference to .init.text:el1_probe from .text between 'init_module' (at offset 0x146) and 'el_reset'
WARNING: drivers/net/3c503.o - Section mismatch: reference to .init.data: from .text between 'init_module' (at offset 0x47c) and 'el2_block_output'
WARNING: drivers/net/3c503.o - Section mismatch: reference to .init.data: from .text between 'init_module' (at offset 0x485) and 'el2_block_output'
...
WARNING: drivers/net/wd.o - Section mismatch: reference to .init.text:
from .text after 'init_module' (at offset 0x47d)
WARNING: drivers/scsi/megaraid/megaraid_mbox.o - Section mismatch:
reference to .init.text: from .text between 'megaraid_probe_one' (at offset 0x1f00) and 'megaraid_queue_command'
WARNING: drivers/video/aty/atyfb.o - Section mismatch: reference to .init.data: from .text between 'atyfb_pci_probe' (at offset 0x297f) and 'atyfb_set_par'
WARNING: drivers/video/aty/atyfb.o - Section mismatch: reference to .init.text:aty_init_cursor from .text between 'atyfb_pci_probe' (at offset 0x2dc1) and 'atyfb_set_par'
WARNING: drivers/video/macmodes.o - Section mismatch: reference to .init.text:mac_find_mode from __ksymtab between '__ksymtab_mac_find_mode' (at offset 0x0) and '__ksymtab_mac_map_monitor_sense'
WARNING: fs/jffs2/jffs2.o - Section mismatch: reference to .init.text:jffs2_zlib_init from .text between 'jffs2_compressors_init' (at offset 0x81) and 'jffs2_compressors_exit'
WARNING: sound/isa/sb/snd-sbawe.o - Section mismatch: reference to

Quoted 8 lines

.init.text:snd_emu8000_new from .text between 'snd_sb16_probe' (at offset 0x440) and 'snd_sb16_nonpnp_remove'
WARNING: sound/isa/snd-opl3sa2.o - Section mismatch: reference to .init.text: from .text between 'snd_opl3sa2_pnp_cdetect' (at offset 0xe61) and 'snd_opl3sa2_pnp_detect'
WARNING: sound/isa/snd-opl3sa2.o - Section mismatch: reference to .init.text: from .text between 'snd_opl3sa2_pnp_detect' (at offset 0xf52) and 'snd_opl3sa2_put_single'

---
~Randy

#2 lore raw
Quoted 7 lines · Randy.Dunlap
Quoted 3 lines · On Thu, 08 Jun 2006 12:09:46 +0100 Barry Scott wrote:

When I built 2.6.17-rc6 I see a lot of warnings after the MODPOST message about Section mismatch. What did I do wrong in building the kernel and modules?

Quoted 8 lines

Nothing (well, I would use "make all" instead of the last 2 commands and I would use ketchup or
http://www.xenotime.net/linux/scripts/grab-kernel-rc
to optionally download and create new kernel dirs. :)

I'll look at the warnings. Some of them are noise/bogus, I expect...

I edited out the duplicate warnings to cut down the size of the mail. Let me know if you want the full list.

Barry

#3 lore raw
In reply to Barry Scott
Quoted 3 lines · On Thu, 08 Jun 2006 12:09:46 +0100 Barry Scott wrote:

When I built 2.6.17-rc6 I see a lot of warnings after the MODPOST message about Section mismatch. What did I do wrong in building the kernel and modules?

...

Quoted 1 line

Here are some of the warnings:

It would be helpful if someone could look at/work on the section mismatches in the isdn and sound drivers...

I have 6 new patches to post, then I'll be
sweeping the net drivers soon.

Quoted 3 lines

WARNING: drivers/scsi/megaraid/megaraid_mbox.o - Section mismatch:
reference to .init.text: from .text between 'megaraid_probe_one' (at offset 0x1f00) and 'megaraid_queue_command'

Can you see if
http://www.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.17-rc6/2.6.17-rc6-mm1/broken-out/megaraid_mbox-fix-section-mismatch-warnings.patch
fixes the megaraid warning for you?

---
~Randy

#4 lore raw
Quoted 8 lines · Randy.Dunlap
Quoted 3 lines · On Thu, 08 Jun 2006 12:09:46 +0100 Barry Scott wrote:

When I built 2.6.17-rc6 I see a lot of warnings after the MODPOST message about Section mismatch. What did I do wrong in building the kernel and modules?

...

Quoted 9 lines
Quoted 2 lines

Here are some of the warnings:

It would be helpful if someone could look at/work on the section mismatches in the isdn and sound drivers...

I have 6 new patches to post, then I'll be
sweeping the net drivers soon.

The alsa folks have fixed their problem and you should see a patch from them shortly.

Any news on the net driver problems?

Barry

#5 lore raw
Quoted 16 lines · On Mon, 12 Jun 2006 14:25:39 +0100 Barry Scott wrote:
Quoted 15 lines · Randy.Dunlap
Quoted 4 lines · On Thu, 08 Jun 2006 12:09:46 +0100 Barry Scott wrote:

When I built 2.6.17-rc6 I see a lot of warnings after the MODPOST message about Section mismatch. What did I do wrong in building the kernel and modules?

...

Quoted 2 lines

Here are some of the warnings:

It would be helpful if someone could look at/work on the section mismatches in the isdn and sound drivers...

Quoted 7 lines
Quoted 3 lines

I have 6 new patches to post, then I'll be
sweeping the net drivers soon.

The alsa folks have fixed their problem and you should see a patch from them shortly.

Any news on the net driver problems?

Sorry, I posted patches for a bunch of net drivers and forgot to copy you on them. On Sat., 2006-June-10, on the netdev mailing list, patches for smc, hp, & 3c5zz:

http://marc.theaimsgroup.com/?l=linux-netdev&m=114997161622800&w=2
http://marc.theaimsgroup.com/?l=linux-netdev&m=114997161630191&w=2
http://marc.theaimsgroup.com/?l=linux-netdev&m=114997161722035&w=2

---
~Randy