mpt fusion - fibre channel target

There's another problem. The routines doing the wakeup don't have access to the sleep variable so the thread sleeps forever.

Quoted 2 lines · Michael Reed

There's another problem. The routines doing the wakeup don't have access to the sleep variable so the thread sleeps forever.

Mike - I think I addressed all the concerns with this patch, however if mpt_config is re-enterant, then all bets are off. Perhaps a mutex might work. Pls review and comment.

Eric Moore
LSI Logic

diff -uarpN b/drivers/message/fusion/mptbase.c a/drivers/message/fusion/mptbase.c

drivers/message/fusion/mptbase.c +25 -9

@@ -121,6 +121,11 @@ static int	mpt_base_index = -1;
 static int	last_drv_idx = -1;
 
 static DECLARE_WAIT_QUEUE_HEAD(mpt_waitq);
+/* This waitq is used for mpt_get_msg_frame failures which may be
+ * caused either by the ioc->active being zero or by the adapter being
+ * out of frames.  Receiving this event doesn't guarantee that a frame
+ * is available, so you must check */
+static DECLARE_WAIT_QUEUE_HEAD(mpt_mf_waitq);
 
 /*=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*/
 /*

@@ -722,6 +727,13 @@ mpt_device_driver_deregister(int cb_idx)
 	MptDeviceDriverHandlers[cb_idx] = NULL;
 }
 
+static void
+mpt_ioc_activate(MPT_ADAPTER *ioc)
+{
+	ioc->active = 1;
+	ioc->mf_wait_done = 1;
+	wake_up(&mpt_mf_waitq);
+}
 
 /*=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*/
 /**

@@ -851,15 +863,21 @@ void
 mpt_free_msg_frame(MPT_ADAPTER *ioc, MPT_FRAME_HDR *mf)
 {
 	unsigned long flags;
+	int	freeq_list_empty;
 
 	/*  Put Request back on FreeQ!  */
 	spin_lock_irqsave(&ioc->FreeQlock, flags);
+	freeq_list_empty = list_empty(&ioc->FreeQ);
 	mf->u.frame.linkage.arg1 = 0xdeadbeaf; /* signature to know if this mf is freed */
 	list_add_tail(&mf->u.frame.linkage.list, &ioc->FreeQ);
 #ifdef MFCNT
 	ioc->mfcnt--;
 #endif
 	spin_unlock_irqrestore(&ioc->FreeQlock, flags);
+	if (freeq_list_empty) {
+		ioc->mf_wait_done = 1;
+		wake_up(&mpt_mf_waitq);
+	}
 }
 
 /*=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*/

@@ -1544,7 +1562,7 @@ mpt_resume(struct pci_dev *pdev)
 
 	/* enable interrupts */
 	CHIPREG_WRITE32(&ioc->chip->IntMask, MPI_HIM_DIM);
-	ioc->active = 1;
+	mpt_ioc_activate(ioc);
 
 	printk(MYIOC_s_INFO_FMT
 		"pci-resume: ioc-state=0x%x,doorbell=0x%x\n",

@@ -1645,7 +1663,7 @@ mpt_do_ioc_recovery(MPT_ADAPTER *ioc, u3
 				dprintk((KERN_INFO MYNAM ": alt-%s reply irq re-enabled\n",
 						ioc->alt_ioc->name));
 				CHIPREG_WRITE32(&ioc->alt_ioc->chip->IntMask, MPI_HIM_DIM);
-				ioc->alt_ioc->active = 1;
+				mpt_ioc_activate(ioc->alt_ioc);
 			}
 
 		} else {

@@ -1803,7 +1821,7 @@ mpt_do_ioc_recovery(MPT_ADAPTER *ioc, u3
 	if (ret == 0) {
 		/* Enable! (reply interrupt) */
 		CHIPREG_WRITE32(&ioc->chip->IntMask, MPI_HIM_DIM);
-		ioc->active = 1;
+		mpt_ioc_activate(ioc);
 	}
 
 	if (reset_alt_ioc_active && ioc->alt_ioc) {

@@ -1811,7 +1829,7 @@ mpt_do_ioc_recovery(MPT_ADAPTER *ioc, u3
 		dinitprintk((KERN_INFO MYNAM ": alt-%s reply irq re-enabled\n",
 				ioc->alt_ioc->name));
 		CHIPREG_WRITE32(&ioc->alt_ioc->chip->IntMask, MPI_HIM_DIM);
-		ioc->alt_ioc->active = 1;
+		mpt_ioc_activate(ioc->alt_ioc);
 	}
 
 	/*  Enable MPT base driver management of EventNotification

@@ -4072,7 +4090,6 @@ WaitForDoorbellReply(MPT_ADAPTER *ioc, i
  *	Return: 0 for success
  *	-ENOMEM if no memory available
  *		-EPERM if not allowed due to ISR context
- *		-EAGAIN if no msg frames currently available
  *		-EFAULT for non-successful reply or no reply (timeout)
  */
 static int

@@ -4394,7 +4411,6 @@ mptbase_raid_process_event_data(MPT_ADAP
  *	Returns: 0 for success
  *	-ENOMEM if no memory available
  *		-EPERM if not allowed due to ISR context
- *		-EAGAIN if no msg frames currently available
  *		-EFAULT for non-successful reply or no reply (timeout)
  */
 static int

@@ -5057,7 +5073,6 @@ SendEventAck(MPT_ADAPTER *ioc, EventNoti
  *
  *	Returns 0 for success
  *	-EPERM if not allowed due to ISR context
- *	-EAGAIN if no msg frames currently available
  *	-EFAULT for non-successful reply or no reply (timeout)
  */
 int

@@ -5083,10 +5098,11 @@ mpt_config(MPT_ADAPTER *ioc, CONFIGPARMS
 
 	/* Get and Populate a free Frame
 	 */
-	if ((mf = mpt_get_msg_frame(mpt_base_index, ioc)) == NULL) {
+	while ((mf = mpt_get_msg_frame(mpt_base_index, ioc)) == NULL) {
 		dcprintk((MYIOC_s_WARN_FMT "mpt_config: no msg frames!\n",
 				ioc->name));
-		return -EAGAIN;
+		ioc->mf_wait_done = 0;
+		wait_event(mpt_mf_waitq, ioc->mf_wait_done);
 	}
 	pReq = (Config_t *)mf;
 	pReq->Action = pCfg->action;

diff -uarpN b/drivers/message/fusion/mptbase.h a/drivers/message/fusion/mptbase.h

drivers/message/fusion/mptbase.h +1 -0

@@ -602,6 +602,7 @@ typedef struct _MPT_ADAPTER
 	FCPortPage0_t		 fc_port_page0[2];
 	struct timer_list	 persist_timer;	/* persist table timer */
 	int			 persist_wait_done; /* persist completion flag */
+	int			 mf_wait_done;
 	u8			 persist_reply_frame[MPT_DEFAULT_FRAME_SIZE]; /* persist reply */
 	LANPage0_t		 lan_cnfg_page0;
 	LANPage1_t		 lan_cnfg_page1;