Missing newline in acpi messes up dmesg output

Hi,

There's a tiny bug in 2.6.18-rc1.
In drivers/acpi/bus.c::acpi_bus_set_power() there's a check to see if the device is power_manageable and if not then print a debug message and return -ENODEV. The debug printk() is missing a \n.

The printk statement looks like this :

printk(KERN_DEBUG "Device `[%s]' is not power manageable",
device->kobj.name);

As you can see, there's no newline at the end, and that causes problems for the next message to be printed.

On my system the above results in this in dmesg :

...
Device `[PEB1]' is not power manageable<6>ACPI: PCI Interrupt 0000:00:01.0[A] -> GSI 29 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:00:01.0 to 64
Device `[PEB2]' is not power manageable<6>ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 34 (level, low) -> IRQ 17
...

Adding a newline (as the patch below does) turns this into

...
Device `[PEB1]' is not power manageable
ACPI: PCI Interrupt 0000:00:01.0[A] -> GSI 29 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:00:01.0 to 64 Device `[PEB2]' is not power manageable
ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 34 (level, low) -> IRQ 17
...

Which is much nicer :-)

---

 drivers/acpi/bus.c |    2 +-
 1 files changed, 1 insertion(+), 1 deletion(-)

@@ -192,7 +192,7 @@ int acpi_bus_set_power(acpi_handle handl
 	/* Make sure this is a valid target state */
 
 	if (!device->flags.power_manageable) {
-		printk(KERN_DEBUG "Device `[%s]' is not power manageable",
+		printk(KERN_DEBUG "Device `[%s]' is not power manageable\n",
 				device->kobj.name);
 		return -ENODEV;
 	}