Skip to contentSkip to conversation

Add one VID/PID to ftdi_sio

PATCH New Colin Leroy 1 participant 1 message Jul 11, 2006

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Add one VID/PID to ftdi_sio

Hi,

This patch adds the Testo USB interface to the list of devices recognized by the ftdi_sio module. This device is based on a FT232BL chip, and is used as an interface to get data from digital sensors (thermometer, etc). See http://www.testo.com/

drivers/usb/serial/ftdi_sio.h +7 -0
@@ -436,6 +436,13 @@
  */
 #define FTDI_ACG_HFDUAL_PID		0xDD20	/* HF Dual ISO Reader (RFID) */
 
+/*
+ * Testo products (http://www.testo.com/)
+ * Submitted by Colin Leroy
+ */
+#define TESTO_VID			0x128D
+#define TESTO_USB_INTERFACE_PID		0x0001
+
 /* Commands */
 #define FTDI_SIO_RESET 		0 /* Reset the port */
 #define FTDI_SIO_MODEM_CTRL 	1 /* Set the modem control register */
drivers/usb/serial/ftdi_sio.c +1 -0
@@ -500,6 +500,7 @@
 	{ USB_DEVICE(ICOM_ID1_VID, ICOM_ID1_PID) },
 	{ USB_DEVICE(PAPOUCH_VID, PAPOUCH_TMU_PID) },
 	{ USB_DEVICE(FTDI_VID, FTDI_ACG_HFDUAL_PID) },
+	{ USB_DEVICE(TESTO_VID, TESTO_USB_INTERFACE_PID) },
 	{ },					/* Optional parameter entry */
 	{ }					/* Terminating entry */
 };
Signature · 1 line
Colin