hwmon: Add support for DS1682

index 0e31a0c..2a45d83 100644
@@ -129,6 +129,31 @@ config SENSORS_DS1621
 	  This driver can also be built as a module.  If so, the module
 	  will be called ds1621.
 
+config SENSORS_DS1682
+        tristate "Dallas Semiconductor DS1682"
+        depends on HWMON && I2C && EXPERIMENTAL
+        help
+          If you say yes here you get support for Dallas Semiconductor
+          DS1682 total elapsed time recorder.
+
+          This driver can also be built as a module.  If so, the module
+          will be called ds1682.
+
+config SENSORS_DS1682_RESET
+        bool "Enable DS1682 Config and Reset capabilities"
+        depends on SENSORS_DS1682
+        help
+          This enables the configuration phase of the ds1682.  Once you
+          setup the config register to your liking you can issue a reset
+          command by doing, for example:
+                
+                  echo 55 > /sys/bus/i2c/devices/0-006b/reset
+
+          twice. This permanently locks the device into its current
+          configuration.
+
+          YOU CAN ONLY DO THIS ONCE.  Subsequent resets are ignored.
+
 config SENSORS_F71805F
 	tristate "Fintek F71805F/FG"
 	depends on HWMON && EXPERIMENTAL

index 3141584..d435011 100644
@@ -20,6 +20,7 @@ obj-$(CONFIG_SENSORS_ADM1031)	+= adm1031
 obj-$(CONFIG_SENSORS_ADM9240)	+= adm9240.o
 obj-$(CONFIG_SENSORS_ATXP1)	+= atxp1.o
 obj-$(CONFIG_SENSORS_DS1621)	+= ds1621.o
+obj-$(CONFIG_SENSORS_DS1682)	+= ds1682.o
 obj-$(CONFIG_SENSORS_F71805F)	+= f71805f.o
 obj-$(CONFIG_SENSORS_FSCHER)	+= fscher.o
 obj-$(CONFIG_SENSORS_FSCPOS)	+= fscpos.o