Skip to contentSkip to conversation

2.6.17 transparent bridge report

DISCUSSION talisein 1 participant 1 message Jul 13, 2006

lore
Share & tools
lore

talisein

author
#0 lore raw

Hello!

dmesg asked that I enable pci=assign-busses and report the results here. Hardware is Alienware 7700 laptop, will happilly respond with more info if needed.
Applicable (?) data below:

ACPI: bus type pci registered
PCI: BIOS Bug: MCFG area is not E820-reserved
PCI: Not using MMCONFIG.
PCI: PCI BIOS revision 2.10 entry at 0xfd951, last bus=10 Setting up standard PCI resources
ACPI: Subsystem revision 20060127
ACPI: Interpreter enabled
ACPI: Using IOAPIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (0000:00)
PCI: Probing PCI hardware (bus 00)
PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1 Boot video device is 0000:01:00.0
PCI: Transparent bridge - 0000:00:1e.0
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PEG_._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCIB._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 10) *11
ACPI: PCI Interrupt Link [LNKB] (IRQs *11)
ACPI: PCI Interrupt Link [LNKC] (IRQs 10) *5
ACPI: PCI Interrupt Link [LNKD] (IRQs 11) *10
ACPI: PCI Interrupt Link [LNKE] (IRQs *10)
ACPI: PCI Interrupt Link [LNKF] (IRQs *11)
ACPI: PCI Interrupt Link [LNKG] (IRQs 10) *0, disabled.
ACPI: PCI Interrupt Link [LNKH] (IRQs 11) *10
ACPI: Embedded Controller [EC] (gpe 29) interrupt mode.

Signature · 2 lines
Andrew Potter
[email protected]