ls command problem
I have some doubts about jffs2
I loaded my jffs2 filesystem in flash 11-63 sectors.
when I used ls command 1st time in u-boot in gives error like below
USCP# ls
Scanning JFFS2 FS: .... add_node: malloc failedadd_node failed!
ls: Failed to scan JFFSv2 file structure
but from 2nd time onwards it giving the list of my filesystem. 1)Why 1st time it's not working ?
2) Is possible to add new file in jffs2 from u-boot?
Thanks & Regards
Srinivas Rao.Ch
---------------------------------
Here's a new way to find what you're looking for - Yahoo! Answers
Send FREE SMS to your friend's mobile from Yahoo! Messenger Version 8. Get it NOW
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20060907/f1bab098/attachment.htm
Quoted 2 lines · In message <[email protected]> you wrote:
I have some doubts about jffs2
You gotta learn to read error messages.
Quoted 5 lines
I loaded my jffs2 filesystem in flash 11-63 sectors.
when I used ls command 1st time in u-boot in gives error like belowUSCP# ls
Scanning JFFS2 FS: ....add_node: malloc failed
-------------------------------------^^^^^^^^^^^^^
Quoted 2 lines
add_nodefailed!
ls: Failed to scan JFFSv2 file structure
malloc failed is a pretty clear message: U-Boot ran out of memory. Please increase the size of the malloc areane in your board config file and try again.
Quoted 2 lines
but from 2nd time onwards it giving the list of my filesystem. 1)Why 1st time it's not working ?
You only think it's working, but actually it shows you only part of the file system.
Quoted 1 line
2) Is possible to add new file in jffs2 from u-boot?
No, there is no write support. The fie system is strictly read-only.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Intuition, however illogical, is recognized as a command prerogative. -- Kirk, "Obsession", stardate 3620.7