Skip to contentSkip to conversation

Uboot for ppc 405GP with vision probe

U-Boot-Users Thanh Nguyen 3 participants 3 messages Sep 13, 2006

lore
Share & tools
lore
#0 lore raw

Hi all,

I'm in internship. It is the first time I use Uboot. I have to load the uboot binary in the flash (AMD 29VL461DH - 8MB - PPC 405GP) with vision Probe. But I got this error message from vision probe each time it tried to load the binary :
"Unable to communicate with the emulator. Please check the physical connection and use the terminal windows..."

I use the lastest version of Uboot : 1.1.4. With the old binary (uboot 0.4.0), it works correctly. Thats why I think there is something wrong in my configuration walnut.h. I will appreciate a lot if anybody can give me a solution of this issue.

Thanks a lot.

NT

#1 lore raw
Quoted 7 lines · In message <1158139574.15965.10.camel@izalco> you wrote:

I'm in internship. It is the first time I use Uboot. I have to load the uboot binary in the flash (AMD 29VL461DH - 8MB - PPC 405GP) with vision Probe. But I got this error message from vision probe each time it tried to load the binary :
"Unable to communicate with the emulator. Please check the physical connection and use the terminal windows..."

Please contact WindRiver technical support. This is off topic here.

Best regards,

Wolfgang Denk

Signature · 6 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Yes, it's a technical challenge, and  you  have  to  kind  of  admire
people  who go to the lengths of actually implementing it, but at the
same time you wonder about their IQ...
         --  Linus Torvalds in <[email protected]>
#2 lore raw
In reply to Thanh Nguyen
Quoted 9 lines · Thanh Nguyen

Hi all,

I'm in internship. It is the first time I use Uboot. I have to load the uboot binary in the flash (AMD 29VL461DH - 8MB - PPC 405GP) with vision Probe. But I got this error message from vision probe each time it tried to load the binary :
"Unable to communicate with the emulator. Please check the physical connection and use the terminal windows..."

Quoted 8 lines

I use the lastest version of Uboot : 1.1.4. With the old binary (uboot 0.4.0), it works correctly. Thats why I think there is something wrong in my configuration walnut.h. I will appreciate a lot if anybody can give me a solution of this issue.

Thanks a lot.

NT

If it truly works with 0.4.0 and not with 1.1.4, I would speculate that your memory map with 1.1.4 is not compatible with your hardware... either your 1.1.4 image is in a different location or it is bigger.

Check your image sizes and locations (objdump for elf, less (the program ;-) for S-record files, xxd and some luck if all you have is a VisionProbe binary lump).

gvb