: Introduce dccp_probe
PATCH 4/4 : Introduce dccp_probe
Hi David,
Please consider pulling from:
master.kernel.org:/pub/scm/linux/kernel/git/acme/net-2.6.git
Best Regards,
- Arnaldo
This adds DCCP probing shamelessly ripped off from TCP probes by Stephen Hemminger.
I've put in here support for further CCID3 variables as well. Andrea/Arnaldo might look to extend for CCID2.
Signed-off-by Ian McDonald <[email protected]>
Signed-off-by Arnaldo Carvalho de Melo <[email protected]>
--- net/dccp/Kconfig | 16 ++++ net/dccp/Makefile | 2 + net/dccp/probe.c | 198 +++++++++++++++++++++++++++++++++++++++++++++++++++++ 3 files changed, 216 insertions(+), 0 deletions(-)
net/dccp/Kconfig +16 -0
@@ -40,6 +40,22 @@ config IP_DCCP_DEBUG Just say N. +config NET_DCCPPROBE + tristate "DCCP connection probing" + depends on PROC_FS && KPROBES + ---help--- + This module allows for capturing the changes to DCCP connection + state in response to incoming packets. It is used for debugging + DCCP congestion avoidance modules. If you don't understand + what was just said, you don't need it: say N. + + Documentation on how to use the packet generator can be found + at http://linux-net.osdl.org/index.php/DccpProbe + + To compile this code as a module, choose M here: the + module will be called dccp_probe. + + endmenu endmenu
net/dccp/Makefile +2 -0
@@ -11,9 +11,11 @@ dccp_ipv4-y := ipv4.o dccp-$(CONFIG_IP_DCCP_ACKVEC) += ackvec.o obj-$(CONFIG_INET_DCCP_DIAG) += dccp_diag.o +obj-$(CONFIG_NET_DCCPPROBE) += dccp_probe.o dccp-$(CONFIG_SYSCTL) += sysctl.o dccp_diag-y := diag.o +dccp_probe-y := probe.o obj-y += ccids/
net/dccp/probe.c new file +198 -0
198 lines not on this page · raw message
Signature · 1 line
1.4.2.1.g3d5c