Debian etch rc1 & daily build install fail on C160

I've tried installing Debian Etch rc1 and yesterday's daily build on my C160, and both fail. The installation itself seems to work fine, but when it boots after, it can't find the root partition.

I don't know if it's because the kernel doesn't have the SCSI driver I need, or if I'm running into the issue listed on the errata:

Disk devices may change on reboot
On systems with multiple diskcontrollers, the kernel/udev may assign a different device node on reboot of the system than was used during installation due to difference in load order of drivers. This can lead to failure to boot the system. In most cases this can be rectified changing the bootloader configuration and /etc/fstab, possibly using the rescue mode of the installer.

Note however that this problem may occur again on subsequent boots. Fixing this issue has priority for the next release of Debian installer.

Is this something I should be reporting here, or to Debian?
_______________________________________________
parisc-linux mailing list [email protected]
http://lists.parisc-linux.org/mailman/listinfo/parisc-linux

The "etch" system is setup to handle discovery order for cd's and network interfaces while keeping device names the same.

The scsi rules are not set up to stabilize the assignments in a similar manner, but should be easy to fix.

Look in /etc/udev/ and /etc/udev/rules.d

- tweak /etc/udev/persistent.rules
to work the same as the pair: /etc/udev/persistent-net-generator.rules and /etc/udev/rules.d/z25_persistent-net.rules

I.E: Turn /etc/udev/persistent.rules into a "generator" of /etc/udev/rules.d/z20_persistent_scsi.rules
and
rename the /etc/udev/rules.d/z20_persistent.rules link into /etc/udev/rules.d/z23_persistent.rules so that it will be run if the corresponding "generator" has not been run.

Contact me off-list if you have trouble with this local solution.

The above is a "local" solution - not approved by Debian. I am not guessing here if their solution will be the same or not.

Mike

_______________________________________________
parisc-linux mailing list
[email protected]
http://lists.parisc-linux.org/mailman/listinfo/parisc-linux

I've tried everything I can think of, but can't get the system to boot.
I finally got smart and checked /proc/modules after a failed boot (at
the initramfs prompt) and found that only an ide driver was loaded. Not exactly what a C160 needs.

So, it doesn't look like a device ordering problem - it's a lack of device problem. Other than compiling a kernel to hard-code the correct devices in, does anyone have suggestions as to how to get the right drivers to auto-load?
_______________________________________________
parisc-linux mailing list [email protected]
http://lists.parisc-linux.org/mailman/listinfo/parisc-linux

The Zalos driver is missing from Debian. I feel like an idiot now.

Is this missing by design? Anyone I can convince to add it?
_______________________________________________
parisc-linux mailing list [email protected]
http://lists.parisc-linux.org/mailman/listinfo/parisc-linux